LED Load Line Resistor Fix LED Load Line Resistor Fix

Note: Resistor Loaders might be very hot, so don't mount on plastic. Also designed to be installed with HID kits that flicker and cause dash light out warnings. These have to be installed onto the HID wiring as shown in the picture.
Warranty: 12 Months High quality replacement part at fraction of cost of dealers. We say they are 6-8 Ohms depending on inventory and stock
Includes 2
Will get Hot, do not mount on plastics
These 6-8 Ohm, 50 Watt resistors will work on any vehicle and can be connected across the turn signal bulbs/headlight wires to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal problems such as hyper flashing, no flashing or burnt out bulb indications. One resistor is required for each turn signal bulb or headlight plug. Installation is simple; just connect one wire of the resistor to the ground and the other one to the positive wire. The Resistor should run parallel to each other.