Electric Winch, Voltage Rating 115VAC, Motor HP 1, Gear Type Spur Gear, 1st Layer Line Pull 2700 lb., Full Load Line Speed 3.5 fpm, Full Load Amps 8, Clutch Release No, Clutch Type None, Pulley Block No, Included Rope Dia. 7/32 In., Included Rope Length 25 ft., Mechanical Brake Yes, Overall Length 11-3/8 In., Overall Width 8-1/16 In., Overall Height 8 In.No Load Line Speed 18 fpm, Gear Ratio 570:1, 1st Layer Line Speed 3.5 fpm, Drum Capacity for 1/4 In. Cable 68 ft.Rope Material Wire RestrictionsNote: Not recommended for outdoor use or areas where units could get wet. Should be used with a ground fault circuit interrupter. Spur GearRating is based on the third layer of cable rather than the first for a more realistic estimate of actual use. Dayton models have precision needle bearings and heat-treated steel drive gears. High-impact cover and brushed stainless steel front plate completely enclose cable and drum. Include factory-installed remote control with 10-ft. cord. Dynamic motor brake and friction brake hold loads securely. Dutton-Lainson Strongarm models are rugged, high-performance winches with efficient spur gear systems for longer run time. Compact design allows for use in tight spaces. Precision needle bearings provide low friction and longer life. Final drive hears are heat-treated, high carbon steel for greater strength.AC Electric WinchesInclude power In/Out. Run on standard household current. Pulling capacity given as a reference only and does not include friction factors that will vary according to specific applications.