Habey HB-LR1007-60W Power Standard 60W ATX board with 20pin or 24pin power configuration and +12V DC input - OEM

Pros: It works

Cons: It broke within 10 minutes of powering on, the craftsmanship is bad. The PSU is open and short circuited with a wire near it. I RMA'd it but due to some small scratches newegg didn't accept it at all. Although the problem was hardware and not cosmetic.

Other Thoughts: Don't buy it. Make your own micro atx combo case.

Pros: Paired with a commonly available 60W (12V 5A) or higher, 5.5mm x 2.5mm tip LCD monitor power supply, this power supply is a fantastic passive and efficient solution for low-power PCs. My company builds custom passive-cooling PCs with these and a custom fabricated metal plate that goes over the empty power supply hole in a compact case. Our corporate Linux router with an Intel D510MO Atom-based motherboard and a 32GB SSD is completely silent and runs around 17 watts of power consumption at idle. Running the same combo on the mini-ITX power supply it replaced, consumption was about 25 watts. Pairing a fully decked out Atom D525 with a SATA desktop hard drive and SATA DVD-RW drive, this supply still laughs it off with a maximum peak power usage of around 30 watts, which is only half its rating! If you need a truly silent custom-built solution, this is definitely THE power supply you need. However, see the Cons section for some caveats.

Cons: While the supply is a solid solution for low-power applications, there are two MAJOR problems that will need to be considered before buying:

1. This supply comes with NO MOUNTING HARDWARE. You must supply your own mounting solution. Driving a metal motherboard mount post into the center of two square adhesive zip tie mounts works fairly well.

2. Newegg regularly fails to ship all of the components shown in photos. We were happily using the DC power jack pigtail which mounts through a hole and uses a nut to lock down onto the metal plate...until Newegg's shipments suddenly didn't contain this part anymore. The black two-screw-mount pigtail doesn't come with mount screws. Again, custom mounting solutions may be required.

Other Thoughts: I have written to Newegg about the missing parts. Hopefully they will take care of the problem.