Showing Results: Most Recent
This review is from: XIGMATEK HDC-D802 Aluminum Hard Drive Cooler for HDD Bay
Pros: Cheap, quiet, good for direct airflow across your hdd chips as long as your case has enough air to flow. Seriously for the negative reviewer, you're not going to see much temp reduction if you're blowing stagnant hot air across your chips.
Other Thoughts: You could easily change fans in this if you needed to, which is a plus. Will fit in the rail bays of an areocool cyclone if you leave two screws out and use the clips instead.READ FULL REVIEW
Pros: Speed, capacity, all awesome
Cons: See other, because I've been using g skill for a long long time now.
Other Thoughts: Some motherboards do not play well with this ram and try to set it to 1333mhz. Not normally a problem, as you just manually set timing. However, my new mb required some truly esoteric settings to stick. If you find yourself in this situation call a young priest and an old priest, then RMA your board, NOT this RAM. Runs great at 1866.READ FULL REVIEW
Pros: Bad mistake to discontinue this. I got it for ten bucks cheaper than just the processer alone. I used the cooler for a few weeks on a phenom ii 940 and got 26c temps. Averaging 37c on the 8c. Both are 125w processors so I'm guessing the mb and ram change has more to do with this. Stable, fast, good buy.
Other Thoughts: Asetek water cooler, worth the money. Fx light is able to be programmed to any cooler you want. Keep an eye out if they offer this cooler on another processer. Worth every penny.READ FULL REVIEW