Notes
- Please insert the filament into the side holes after use to avoid tangles.
- Please stored the 3D printer filament in a sealed bag or box after using it.
- Feel free to message us if you have any questions about the filament.
Q: Why can't the filaments stick to the build bed easily?
A: Please do 3 steps checking!
- Temperature
Please check the temperature(bed and nozzle) settings before printing and set it suitable.
- Building Bed
Please check if the bed is level, make sure the nozzle doesn't too far or too close to the bed.
- Speed
Please check if the printing speed of the first layer is too fast(Recommended: 20-40mm/s).
Recommended Settings:
- Nozzle 210°C - 235°C (410°F - 455°F)
- Bed 70°C - 80°C (158°F - 176°F)
- Printing Speed: 40-80(mm/s)
- These settings are for 0.4mm nozzle, it may be different with different diameters nozzle