SANSI LED Security Motion Sensor Outdoor Lights, 36W (250W Incandescent Equivalent) 3600lm, 5000K Daylight, Dusk to Dawn IP65 Waterproof Flood Light, ETL Listed, White

SANSI 36W Dusk to Dawn LED Security Lights Keep Your Family Safe with SANSI LED Security Lights! Compared with other security lights, SANSI LED security motion activated light can be rated at 3600lm just with 36W, which is far brighter to provide security for your home or business accommodations. You could cut down your electricity bill by up to 85%. Compared with traditional motion sensor light for outdoor, it has more working modes. Not only owns Test, Auto Mode, but also includes Dusk to Dawn Mode and On Time Mode.

4 different working modes will meet your needs. Four Kinds of
Working Modes: 1.
TEST MODE Set-up: Put the "Mode" switch at Test position.
Function: Light turns on for only 5 seconds during daytime or night once it detects motion. This mode is used for checking whether the sensor is working properly. Test Mode can work during daytime and night. Except Range, the Lux and Time Setting doesn't work while using this mode. 2.
AUTO MODE Set-up: Put the "Mode" switch at Auto position.
Function: When sensor detects motion, it lights up for 1-10 minutes according to the time it has been set. While using auto mode, toggle switch off and 2 seconds later on again. Light turns on continuously for ca. 8 hrs and goes off at daytime. Auto Mode only works at night. When it's bright (> 100-150 LUX) around the sensor, light goes automatically back to Auto Mode. 3.
ON TIME MODE Set-up: Put the "Mode" switch at On Time position.
Function: Light can work as a standard LED light without motion sensing. Light turns on when switch on, turns off when switch off. On Time Mode can work during daytime and night. The Lux, Time and Range Setting doesn't work while using this mode. 4.
DUSK TO DAWN MODE Set-up: Put the "Mode" switch at D2D position.
Function: Light turns on automatically at dusk or night and turns off at dawn or if it’s too bright for your sensor. D2D Mode only works at night. When it's bright around the sensor, it goes off automatically. Except Lux, Time and Range doesn't work while using this mode.
Three Setting Knobs: 1. Sensor Sensitivity For setting ambient brightness value to differ from daytime to night. If the ambient brightness value exceeds the setting Lux, it is defined as "daytime"; otherwise it's known as "nighttime". Position 0 equals 3 Lux, Position 8 equals max Lux and it's always regard as night no matter how bright around the sensor. Lux setting only works in Auto Mode and D2D Mode. 2. Detecting Range Rotate the knob to adjust the sensing range to max ca. 50ft motion coverage. When you mount the light over 7.8 ft, please adjust the sensor upwards and set max range to increase the coverage area. Time setting only works in Auto Mode. Range setting only works in Test Mode and Auto Mode. 3. Stand By Time Time knob is used for setting working time from 1-10 minutes when it detects motion. Time setting only works in Auto Mode.