The Accelero L2 Plus is a cross compatible VGA cooler designed for low end to mid-range graphic cards, same as his predecessor L2 Pro but with a wider compatibility and enhanced RAM and VR cooling. A comprehensive RAM/VR cooling set is also included to improve the cooling performance of RAM/VR.
Cooling PerformanceFeaturing a 92 mm PWM fan and a cooling capacity of 120 Watts, the Accelero L2 Plus ensures components are performing under ideal temperature. The pre-applied MX-4 thermal compound allows enhanced thermal conductivity from the GPU, thus considerably extending its service life.
Enhanced RAM and VR CoolingIn order to boost the cooling efficiency of RAM and VR, the Accelero L2 Plus comes with the G-1, an electrically non-conductive thermal glue used to affix RAM and VR heatsinks on the VGA board. Unlike generic thermal tapes, the G-1 offers high thermal conductivity with excellent adhesiveness. Moreover, removing the G-1 is extremely easy without leaving any residues.
Virtually SilentOperated by a low noise impeller enclosed in a unique fan holder to reduce the buzzing sound when the fan is spinning, the Accelero L2 Plus is barely audible even running at full load. To enable minimum noise level at all circumstances, the PWM controller enables the fan to run at the optimal speed according to the load generated by the GPU.
Multi-Compatible*To accommodate a broad range of models, the Accelero L2 Plus comes with a versatile mounting mechanism and an extensive RAM and VR cooling set consisting of 16 pieces of RAM/VR heatsinks in various sizes. Featuring the CrossFireX and SLI compatibility the users benefit from the optimized performance of a multi-VGA setup. (*The compatibility list is based on AMD Radeon and NVIDIA's reference board layout only.)
Pros: - At least a 30° F improvement over passive cooling (OEM heat sink only) - 27 CFM (I did not measure, but this spec seems to hold true - air flow is outstanding) - Adaptive (multiple fastener options and both 3 and 4 pin fan connectors) - Quiet - Value (price) If your choice of GPU cooling is a heat sink and fan, then this should be your choice. It is notable that this cooler's success relies on a heat sink that is HUGE. It absolutely needs space and could block access to expansion slots. The cooler blocked my PCI-E x1 and a PCI slot on the micro-ATX board I was using at the time (I have since switched to full size ATX which eliminated that issue), While some may see the size as a problem, I don't since the design accomplishes effective GPU cooling. Please note that I own this product and the fan failed after about two years of service. That is the only reason for my rating loses an egg. I requested a replacement from ARCTIC and they replied and acted immediately (per their e-mail address at "Warranty and Return" tab). It is also notable that the fan clips to the heat sink so installation couldn't have been easier (no vibration btw). I have extensive experience building PCs had have many OEM graphic card fans fail over the years. I am not making excuses on behalf of ARCTIC, but it seems that the MTTF for these type of fans is short (if there even is a MTTF calculation). 2 -3 year seems to be typical. ARCTIC's 6 year warranty on this produce combined with their prompt RMA covers that risk quite well.
Cons: None.
Overall Review: I love sensible engineering. I would recommend and use this product again and again.