Sold by: ForthwithIndustry ForthwithIndustry
  • $4.99
  • $2.04 Shipping ()

Are you an E-Blast Insider?

Newegg

Shop without retyping payment details. Secure shopping made faster.

Check out with PayPal.

Infinite Products Bottom Base Rubber Feet Foot Pad for Apple MacBook Pro & MacBook Retina A1425 A1502 (MacBook Pro 2008-2011)…

In stock.
Ships from United States.
  • MacBook Pro 13"
  • Macbook Pro 13” A1278
  • Macbook Pro Rubber Feet Replacement bottom case feet. Made with real rubber not plastic so will not slide around. Leave on for 24 hours with pressure for full adhesive to bind to macbook.
Choking Hazard Small parts. Not for children under 3 years.
Overview
Specs
Reviews
DIY Foot Replacement Instructions
Note: Use the foot replacement kit for missing feet only. Do not replace well-adhered feet. Removing feet for the sake of replacement can damage the bottom case.
Tools Needed to Complete Repair:
• Pentalobe 00 screwdriver
• Tweezers
• Paper clip or safety pin
Gloves are suggested for this procedure.
Preliminary Step
Before you begin, check the foot location requiring replacement and verify that the case plug, and the case foot in the kit, match the pictures below.??
1. Place the computer upside down on a clean, lint-free cloth or other nonabrasive surface. Remove the bottom case.??
2. Using the Pentalobe 00 screwdriver, remove the bottom case by removing 10 screws. Important: Screws at sides and front must be removed and installed at an angle.??
3. Gently pull the bottom case from the side the display hinges are on and lift upwards at an angle.??
4. Make sure the foot area on the bottom case is clean and free of debris. If any portion of the foot adhesive remains, peel it up with a pair of tweezers.??
5. Clean both sides of the bottom case around the foot area. Allow the alcohol to evaporate.??
6. Peel the outer foot from its packaging and affix it firmly to the bottom case. Use the glue to adhere the outer foot to the bottom case. Avoid touching the adhesive backing.
7. Use a paperclip or safety pin to open the glue nozzle. A paperclip or safety pin can also unplug the glue nozzle after storage. Apply a very small drop of glue on the bottom of the foot on the bottom case. Do not spread the glue. ?
8. Seat the plug onto the glued area.??
9. Do not use your finger to press the foot plug down. Use the wooden end of a cotton swab to press the foot plug into place. Lightly press and hold the foot in place for 30 seconds.??
10. Clean any excess glue with a cotton dry swab. Important: Do not wipe the glue; use the cotton dry swab to absorb any excess glue. Excess puddled glue may take hours to dry and may cause the bottom case to adhere to the logic board or interior cabling.??
11. Reassembly Note: Install screws in order shown. If sequence is not followed, bottom case might wobble when placed on level surface.

Warranty & Returns

Warranty, Returns, And Additional Information

Return Policies

Manufacturer Contact Info

LOADING...
TOP