Supports Up To 10x Fans + 2x ARGB Devices
- Connecting 1-6 fans requires only one three-wire SATA power cable connected to PSU SATA cord.
- Connecting 7-10 fans requires two SATA power cables of HUB-I connected to PSU SATA cords.
- NOTE- FOR EZDIY-FAB FANS ONLY
The reset button assists in troubleshooting.
Press the button for 3-5 seconds to reset.
Safety comes first.
- When the green light is on, it indicates that the 5V power supply is functioning normally.
- If the light is off, it signifies a circuit anomaly.
- Both the 5V and 12V terminals on the board are equipped with fuses. Any short circuit will immediately break the connection, preventing any further damage caused by the short circuit.
In addition to using the remote to control your EZDIY-FAB fans, you can synchronize them with motherboard software from ASUS, GIGABYTE, MSI, and ASRock by pressing the M/B button on the remote.
Supports Up To 10x Fans + 2x ARGB Devices
- Connecting 1-6 fans requires only one three-wire SATA power cable connected to PSU SATA cord.
- Connecting 7-10 fans requires two SATA power cables of HUB-I connected to PSU SATA cords.
- NOTE- FOR EZDIY-FAB FANS ONLY
The reset button assists in troubleshooting.
Press the button for 3-5 seconds to reset.
Safety comes first.
- When the green light is on, it indicates that the 5V power supply is functioning normally.
- If the light is off, it signifies a circuit anomaly.
- Both the 5V and 12V terminals on the board are equipped with fuses. Any short circuit will immediately break the connection, preventing any further damage caused by the short circuit.
In addition to using the remote to control your EZDIY-FAB fans, you can synchronize them with motherboard software from ASUS, GIGABYTE, MSI, and ASRock by pressing the M/B button on the remote.
