Specifications:
High-end wire configuration:
Motherboard power supply interface: 20+4P*1
CPU-powered interface:1*4+4p
Graphics power supply interface: 2*6+2p
Hard drive power interface: SATA*3
Hard drive fan power interface: IDE*2
NOTE:
1. The continuous total max. DC output power shall not exceed 750W, +3.3V and +5V,combined continuous output power not exceed 100W Max
2. +12V and +5VSB peak surge current 16sec. max.
3.A 0.1uF and 10uF tantalum capacitors should be put across output terminals during ripple & Noise test. The oscilloscope bandwidth is set at 20 MHz and co-axial probe will be used to measure it.
4.The cross-load regulation in defined in the matrix below.(UNIT: A )
PROTECTION :
If the power supply is latch into shutdown stage (when OCP ,OVP or short protection is working ),the power supply shall return to normal operation only after the fault has been removed and remote signal must reset for a minimum of 1 second(or the AC removed for 10 second) . Then ,it will turn on again .
AUXILIARY +5Vsb
This power supply is specifically equipped with an independent stand-by +5V output current , 2.0A max . This output will always provide +5v except when the AC line is cut-off .
HI-POT
7.1 INPUT TO GND : VOLTAGE 800VAC TIME 2.0~3.0 SEC. CUT OFF CURRENT 10mA MAX
EARTH CONTINUITY TEST : 100mO MAX at 25.0A .
LEAKAGE CURRENT EACH LINE TO GND.
3.5mA MAX. AT 264V 50Hz
ENVIRONMENT :
AMBIENT OPERATION TEMPERATURE 5° to +40°
AMBIENT OPERATION RELATIVE HUMIDITY 20% to 85%
AMBIENT STORAGE TEMPERATURE - 40° to +55°
AMBIENT STORAGE RELATIVE HUMIDITY 10% to 95%
SPEC SIZE:
SHOW SIZE:150*140*86MM
CASE STRUCTURE MACHINERY:I/O INLET+OUTPUT 120mm FAN