Showing Results: Most Recent
This review is from: AMD Radeon HD 6350 Low Profile Video Card For DELL- 1CX3M
Pros: Great for older game titles which will NOT play if you try to play with onboard graphics on my Dell OptiPlex 760. Seller was great when I got in touch with them about the amd radeon hd-6350 turning out to actually be the hd-5450. I do not blame the seller for this as model is not printed on the board and seller was under the impression from dell it was the right board. Board was clean and looked like it never was used...fan was CLEAN and no noise.
Cons: Does not come with weird (DELL being weird of course) DMS-59 Pin to 2 Dual VGA HD15 Female Splitter Adapter Cable which can be purchased separately.
Other Thoughts: You have to download the driver from AMD site which was no biggy. My rig uses xp sp3 on my dell. Great that this board was actually available after all this time...OptiPlex is a 2007 rig so any game titles prior to that time should play fine.READ FULL REVIEW
Pros: Great card as it runs any game especially the new DOOM
Cons: noneREAD FULL REVIEW
Pros: Very roomy case as it is larger than the usual, making connections to the MoBo much easier. Very well designed, however could use some improvements as listed below. Very nice finish inside and out. You can hide cables nicely. Comes with 3 large fans (quiet btw) ...rear front and top. LED colors are nice. Case came with no defects as mentioned by others Utilizes rubber grommets to minimize vibration when installing window fan and hard drives (conventional type). Accomodates SSD's without requiring additional hardware. I purchased this case mainly for helping to cool the GPU with the windows panel fan (200mm) that i had to purchase separately. Also purchased for its dimensions . In so doing I got all these other extras that came with this case. Over all I really like this case...keeps things cooler.
Cons: Side panels do not swing out. Owners manual could be clearer in how to connect the audio cable and USB 3.0 cable. Audio cable for onboard MoBo connection is a bit short and should be lengthened about 3 inches, as the connector is located on my MoBo at the rear edge. Should have interlock on both sides of the 5.25" bays and not just one side..On other side I had to use 2 screws to fasten my device. One egg removed for above reasons.
Other Thoughts: This case has a lot of features and basically I would give it 5 eggs except for the cons listed above. I strongly recommend a modular PSU as although cables can be hid they impede air flow a bit. I have not tried docking yet. Wings are non functional but I guess they give the case a mysterious look lol.READ FULL REVIEW