Question 1

Is it good for acer aspire v5 ?

Accepted Answer

I haven't used it in that particular model, but I have used it in a different Acer and am currently using it in a Toshiba. Both had 4GB to start with. I didn't notice a difference in the Acer, but it was underpowered for what I was doing. The Toshiba is a newer model and the extra ram has made a noticeable difference. I'd buy this same RAM again.

Question 2

I have a gateway NE5641u, will this ram fit?

Accepted Answer

It should work fine, yes. You laptop supports 1333 RAM up to 8GB (2x4GB). If the laptop only has 1 4GB stick already then you will be all set, just remember the stock RAM is 1066 so this will slow down to that to run in parallel.

Question 3

Hello,

I have a gateway nv55c P6100 @2.00ghz 3gb DDR3 ram (two slots : 1 elpida 2gb ddr3 2rx8 pc3 10600 and the other kingston 1gb 1rx8). Will this Team Elite ram work on my computer if I combine it with my elpida 2gb ram?

Thanks,
Youness

Accepted Answer

Yes, should work fine. I can't say with 100% certainty, but I'm 99% sure it would be fine. Chipset supports DDR3 at 1066 dual channel up to 8GB, so a 4GB stick should be fine. Gateway states the laptop can expand up to 8GB as well, so they didn't do anything dumb with the chipset to limit channels.

One thing you should check first is the version of Windows you are running. If it is 32bit, you will not see more than 4GB of the RAM, even with 6GB installed. You must use a 64bit version of Windows to address the full 6GB of RAM.

Question 4

Will this work with a Lenovo Y510p Laptop?

Accepted Answer

It works well in  my labtop - Lenovo Thinkpad T410- . So you need to go to Lenovo. - SUPPORT_ see the specs for yours Y510p and compare. OK!

Question 5

Will this fit in Lenovo thinkpad t520?

Accepted Answer

Not sure, make sure its the same type of memory, for example DDR3 or DDr2 . Im sure everything being made now is DD3. The pin numbers also have to match up. Im not sure how you find this out but I just opened my laptop and saw where the Ram indent was ( on the actual stick itself) then I shopped around for DDR3 with the same indent position.

Question 6

have an acer aspire model 5253 with a1.00ghz cpu what is the socket and up grade it will handle?,yes

Accepted Answer

If you are asking about the CPU socket, there isn't one. The CPU should be soldered to the motherboard, it cannot be upgraded.

If this is a question about this RAM, it should be fine. The RAM will run at 1066, not the full 1333 this RAM is capable of, but it should be supported fine by the motherboard.

Question 7

Will this fit into my eee pc hab netbook?

Accepted Answer

I'm guessing you are talking about an Eee PC 1005HAB. No, those older Eee PCs used DDR2 RAM, this is DDR3.

Question 8

Hey i'm thinking about putting two of these in an all-in-one HP b013W... are they compatible?

Accepted Answer

My research results:
Yes this memory is supported.
The memory supports  PC3-10600 (DDR3-1333). 
You can go up to 2 sticks of 8 Gb of ram.
The total ram supported is 16  Gb.

Question 9

Will this work in a HP 2000 laptop?

Accepted Answer

It depends on the memory already installed and the motherboard.  Open up the bottom memory compartment and get memory speed and latency and get something that matches that exactly.

Question 10

OK for nuc-DE3815tybe?

Accepted Answer

Yea this should work just fine for your computer.

Questions & Answers