BOSS AUDIO 1500W Mono Amplifier

2 Ohm Stable

The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.

Bass Boost

This feature is built-in to the amplifier and allows you to adjust the amount of bass going to your subwoofers or speakers. Depending on the amplifier the adjustments range is from 0 to 12dB or 0 to 18dB.

Class A/B

Class A/B amplifiers have long been known for their ability to produce great quality sound while performing more efficiently than pure Class A amplifiers. We have developed a specific linear circuitry that further reduces distortion while increasing both sound quality and power output.

Crossover Filter

Built-in crossovers enable you to tailor the audio to your system's needs. A High-Pass filter allows only the frequencies above the set frequency to pass through to your full range or component speakers and a Low-Pass filter allows only the frequencies below the set frequency to pass through to your subwoofers so your speakers and subwoofer[s] can perform more efficiently and effectively.

High and Low Level Inputs

An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.

Protection

If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.

Subwoofer Level Control

The wired remote subwoofer level control, mountable for easy access, has long been a popular feature on many of our amplifiers. The remote allows you to control the output level of the subwoofer(s) as needed for optimum sound according to your personal taste and listening environment.

Switchable Input Sensitivity

Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.