Question 1

Will this fit GeForce 7600GS Graphics card? Fan is making a high pitch winding sound and needs a replacement.

Accepted Answer

i got one for a 7600. It did not fit the hole spacing on my card, and the connector plug was also wrong for my card.

Question 2

What is the height of the fan?

I'm looking to replace the custom CPU fan on a tiny Atom-based nettop, and there is very limited head room. I'm not worried about the spacing of the mounting holes, as I have a large metal heat sink I can drill into to make it work.

Accepted Answer

Hi Bobby, OK, to be honest Math is not my strong point. However using a standard Tape Measure, I got 1/2 in. tall as it came from Newegg. You can remove the fan from the Heatsink which would make the Fan around 7/16 in. tall...approx. I've heard that ATOM CPUs run hot, not sure how it runs in a Net-Top, or Net-Book. I am talking about the Logisys V50. I hope this helps, and good luck.

Question 3

What is the mounting pin distance (center-to-center)?

Accepted Answer

55mm

Question 4

can the mounting pins be purchased separately?

Accepted Answer

A lot of people have problems with the long screws as they are rubbish and need to be replaced. I was lucky to have some left over hold down screws from a very large air cooler and the nuts from an old H60 water cooler that went dead and had to be replaced. If you can, lay out all the attaching screws and nuts set aside the 4 black hex nuts , take one of the nuts with you and  one screw to the hard ware store, get a screw that just slides through the nut you took with you and is the same length as the long screw you took with you. Make sure you have a nut driver that fits the 4 nuts you just purchased for these new screws and do not forget lock washers. get a drill bit the size of you new screws and drill out the proper holes in the back plate called for by the instructions for your video card that came with the G10, tighten in an X pattern taking care not to warp the PCB and your done, seems like a lot but getting the hardware from NZXT is impossible.

Questions & Answers