Question 1

Can I put it in a Corsair Obsidian 750D?

Accepted Answer

As long as their are two 5.25" inch drive bays in a row open. Its very nice to have, but the temperature reading is not always super accurate.

Question 2

Does this fan control work with LED lit fans or does it also Dim the LED light at the same time slowing the fan RPM?

Accepted Answer

Hi Shopper, This unit can cause the LED fan to dim if you lower the fan RPM several settings below default manually. Now this has only happened from my IO connectors used for my front intake fans as I have not seen my larger 200 mm fan dim while lowering the settings. This was from my initial install and was playing around to better understand how it worked of course. Based on your type of fans such as (high end) models and bios settings may change how they react. I have since set all my fans to the highest speed but auto control in bios so that the fan will only run as fast as it needs to. With that being said if you unlock the RPM settings and manually control the speed to a low RPM speed @ the fans lowest then yes your fan may or may not use as much power and will dim down.

Question 3

the lower bexzel beneath the lcd--is it able to be removed [modded] would there be enough clearance [or close to enough,possible modding the 5.25 opening] to install a slim BR-RW beneath the lcd ?

Accepted Answer

IMHO I would say no. There is what looks like enough room but the electronics and heat sinks and connectors along with the PCB on the back don't leave room even for the tray of a BR-RW.

Question 4

How do you set the alarm temperatures on the four sensors? I cannot get it to increase and the alarm is really annoying me. I've tried tapping all over the small display to no avail...

Accepted Answer

Make sure that the Lock icon in the middle of the screen does not have a full circle around it, change this by tapping it. Select your sensor you want to change, then tap the temp, this should bring up the alarm set point. Press and hold the alarm set point temp, you should get a beep and temp will start blinking. Use "+" and "-" signs to change alarm set point. Tap temp again to set.

Questions & Answers