XIGMATEK HDC-D802 Aluminum Hard Drive Cooler for HDD Bay

Pros: It cools the hard drive and is reasonably quiet at 2,000 rpm.

Cons: It's cheap looking (overpriced). The fan is sleeve bearing (not ball) and rated at only 40,000 hours.

Overall Review: It's not bad but I'm sure there are better choices for the same money.

Pros: Cheap, quiet, good for direct airflow across your hdd chips as long as your case has enough air to flow. Seriously for the negative reviewer, you're not going to see much temp reduction if you're blowing stagnant hot air across your chips.

Cons: None

Overall Review: You could easily change fans in this if you needed to, which is a plus. Will fit in the rail bays of an areocool cyclone if you leave two screws out and use the clips instead.

Pros: Keeps my hdd 5c cooler.

Cons: Cheaply made but for the price...what do you expect.

Pros: Quiet and easy to install.

Cons: Had to remove one drive bay to make room. I have 7 so I can spare one but may be someone else cant.

Pros: Cools the drive effectively. My WD HDD temp went from 46c under load to 31c. It's also nice and quiet for a 2k RPM fan. Very pleased.

Cons: None.

Overall Review: Comes with a Molex connector, as others have stated. It would be nice if it were a 3 pin. The pins on mine were nice and straight, but bent Molex pins are common on cheaper accessories, as other reviewers have noted.

Pros: Great over all fan cooled my HDD 13°

Cons: Nothing seem to work fine for what it is!!!

Pros: good little fan easy to set up small compact size not sure about this newer case issue but fits good in mine no problems mid tower, so far makes no noise whatsoever..

Cons: none

Pros: I got it for free, and it did what it was supposed to do.

Cons: Bearings sucked in it, and within no time the thing was making so much noise it was un-godly. I gave it away to a friend of mine. Not really worth buying, if you get it for free good for you, but if you REALLY need a hard drive cooler. Get something better.