Antec 761345-75121-6 3-Speed Case Cooling Fan

Pros: Works as described. Extremely quiet on low setting. No LEDs!

Cons: None

Overall Review: I bought this to complement the tri-cool fans that were already preinstalled in my Antec P182 case. As far as I can tell it is the exact same fan.

Pros: Fan works GREAT. It is quiet on normal operation, and if you crank it, you can hear air noise mostly not fan noise, quiet as it is.

Cons: If I was to make an improvement, I would increase the length of the switch cable, but it is effective as is.

Overall Review: To reduce noise from the fan on the case, removing the grid of holes on the case, where the fan mounts makes a great difference at high volume settings. Doing so gets rid of the wooshing/whistling noise through the holes. Also, just popping a little hole in the case, next to the fan to mount the switch on the outside of the case is no big deal. Obviousely, refer to case manufacturer if these adjustments will benefit you.

Pros: What can I say . . . they move the air . . . lots of it. Cables are plenty long and offer all the options you need for power/speed control.

Cons: A little loud on the highest setting . . . but I already knew this from the one that came with my Antec 300. They don't really increase the volume significantly from the rest of my fans. (I added 3 of them)

Overall Review: Just a funny story . . . I installed them and booted my machine. Fired up Speedfan and it reported temps ~15C higher than I'm used to seeing at boot. Spent a few minutes trying to figure out what the heck was going on, then realized that I had configured Prime95 to start at OS boot . . . doh! XD

Pros: Using HWMonitor to check my HP d4100e computer temps before installing this fan, the temps ran: Core 0 = 38 at idle and 47 underload Core 1 = 39 at idle and 49 underload I installed this 120mm fan in the d4100e and after leaving the computer on at idle for 2 hours I dropped the temps dramatically. Core 0 = 29 at idle and 36 underload Core 1 = 30 at idle and 37 underload I rendered an animation that takes about 30 mins to render as the load test in both before and after the fan install. Makes a huge difference. Also the CPU fan stays quite as it doesn't need to rev up to keep the CPU cool. I am running the fan on the highest speed setting. The motherboard temps and the hard drive temps dropped 7 to 8c also.

Cons: Not really a con, but with the fan on high you will hear it. However, it is NOT as loud as when the CPU fan revs up.

Overall Review: This really pulls a lot of air through the computer. When I am rendering an animation the CPU fan really kicks in and is loud. With this fan install, while you do hear the fan on high, the noise is not as loud as the CPU fan when it has to kick in. The trade off was worth it for me.

Pros: Just as described by newegg you can select betweet LOW, MEDIUM and HIGH speed so you are in control of the noise and airflow, it is really quiet in low and tolerable in medium so that is the higest i go with it, but that is plenty of airflow already so no need to crank it up to high.

Cons: not a single one

Overall Review: I had one of these fans that i got from circuit city but i loved it but it had blue LEDs and im not trying to make my case glow like a fast and furious honda civic so newegg was the answer, thanks!

Pros: Bought three of these to go into my Antec 300. It's probably overkill for my current setup since I'm not going to be overclocking too much. On the low setting these fans are silent, and there's only a little noise on the medium setting but I can still hear my video card fan over them on this setting. Hopefully now having 5 fans in the case, I won't ever have to have them on the high setting, because it's very loud!

Cons: Shipping costs. Bums me out that I can get a 12lb monitor shipped for free, but have to pay $15 to get 3 10oz fans shipped. Oh well...

Overall Review: ANTEC 300 Gigabyte EP43-DS3L Core 2 Duo E8400 500GB WD Caviar Black GeForce 9800 GT 4GB OCZ RAM

Pros: Low noise level compared to other fans.

Cons: None, really.

Overall Review: I used this fan on my Antec 900 case to cool my video card, it does a good job of dropping temperatures. I like the speed switch and leave it on the medium setting.

Pros: they move air. work good on mobo header.

Cons: very loud when set on high.