Question 1

Can you adjust the height?

Accepted Answer

Yes, the mount moves up and down with about 15" of travel. I have two 24" monitors the mount is about in the middle of the mounting bar and the and the bottom of the monitors are about 6" above the desk top. This is a very good product.

Question 2

Does this include the mounting hardware (screws?) for two monitors, or will I need to purchase those separately?

Accepted Answer

Mine came with a wide variety of screws that would work for multiple applications and enough for two monitors.

Question 3

Will this stand allow me to have pivot one monitor vertically and have the other in the normal horizontal position?

Accepted Answer

Yes, mount one vertically, one horizontally. The square pattern of the mounting screws will allow you to do it. Tweak as needed. Check the specs to see if it is big enough to work with your monitors.

Question 4

I would like to mount two 24" monitors vertically - one on top of the other. Will this mount lift one of the monitors above the other non-mounted monitor that sits on a desk?

Accepted Answer

No it will not.

Question 5

Would you suggest this if I have one 32" in landscape and a 27" in portrait permanently?

Accepted Answer

I doubt it. The spread btwn the connection points is not wide enough for 2 24in if the monitors have to move forward 10 in or so from support posts. But may be if monitors don't have to move forward over a wide desk. I changed to 2 single post supports.

Question 6

Will this work on my 18 mm think desk?

Accepted Answer

It should. I have mine clamped to an approx. 10mm shelf. The clamp with open much farther, maybe a desk 30mm thick.

Question 7

How tall is the pole for this particular model? And, how far away can the center of the monitor be from the mount point?

Thanks!

Accepted Answer

From clamp to the top the pole, 15 3/4 inches.

With the arm extended straight out, 12 3/4 inches.

Hope that helps.

Question 8

Would this desk mount support two 27" curved monitors? I know it says it supports 2 27" monitors, but I am not sure I trust it and I don't know if the monitors being curved will change anything. The mounting holes will fit correctly, I am just worried that the mount itself will not support two curved screens being held in a fluid curved position. I would not be moving them around at all, so how difficult the joints are to move is not a problem for me.

Accepted Answer

Yes it will hold 2 curved monitors. It comes with an Allen key to tighten the mounts.

Question 9

My desk is against a wall and I have one 24" and one 27" monitor. I also like one monitor facing me and the other off to the side at an angle (interchanging which one is facing me, between the 24" and 27"). Would this mount allow me to switch between those two arrangements, keeping the desk against the wall? I want to know if the arms of the mount need to extend past the back of the desk.

Accepted Answer

No, if you're looking for that kind of movement you would need a mount with greater arm span and smoother motion. This mount is great for a static setup, but it does not have the fluid motion is sounds like you're looking for.

Question 10

Will this support 2 Apple Thunderbolt Displays?

Accepted Answer

Unfortunately I do not have displays to be able to answer this question.

Questions & Answers