C2G 03748 35 Inch Vertical Cable Management Rack

The C2G 03748 is a black, rackmount vertical cable manager measuring 35 inches high by 4.4 inches wide, suited to organizing cables in server and equipment rack setups.

Recommended For

• Network administrators routing patch cords vertically between rack-mounted switches and patch panels who want a dedicated path for adds, moves, and changes.
• Installers outfitting standard EIA 19-inch relay racks with network, datacom, or telecom equipment who need vertical cable routing alongside the rack.
• Technicians routing Cat5e cabling through a rack who want the cable path to help maintain the specified minimum bend radius.
• Rack managers who have room for a 35-inch-high vertical cable manager and want to route patch cords along the rack rather than across its face.

Real-World Use Scenarios

• In a network rack with patch panels and switches, route patch cords vertically beside the equipment instead of letting them hang across the rack face; the front stays easier to inspect and work on.
• When adding or moving network connections, guide each cable through the manager’s fingers so it can be accessed and rerouted without pulling apart an entire bundle.
• When patch cords have excess length, coil the slack inside the cable manager rather than leaving loops loose around rack equipment; the cables remain contained and reachable.
• In a rack carrying cables on both the front and rear, use the manager’s covered front and rear paths to keep the runs organized while preserving access to the cabling.
• When routing Cat5e patch cables vertically, use the guide fingers to avoid forcing tight turns; C2G describes their spacing as helping maintain the cable’s minimum bend radius.

Spec Summary