Question 1

Does this come with a cable to connect it to the motherboard?

Accepted Answer

It connects to a 3/4-pin chassis fan header on a motherboard.

Question 2

What are the 4 pin psu adapters for? MUST you use them? Or can I plug the fans directly into the fan header?

Accepted Answer

The 4 pin adapters are for if you run out of fan headers on the motherboard.

Question 3

Is this a four pack sold as?

Accepted Answer

This is a single fan.  I bought one 140mm fan two years ago to replace the rear case fan in my Thermaltake PC enclosure and it is running cool and quiet.  My CPU cooler fan blows directly on this fan so my need for high air flow from this fan is low.  Your condition may require a stronger fan but I suspect you will receive more noise along with the higher airflow.

Question 4

Is this fan an AC or DC powered fan?

Accepted Answer

In typical computers, the only component that uses alternating current is the power supply. The power supply converts the alternating current to direct current...

Question 5

I pulled a bad fan from my tower, but the label offers no information.  How do I determine if I need the 92mm versus the 140mm?

Accepted Answer

The size of the fan just measure it

Question 6

What are the 4 pin adapters for?

Accepted Answer

If you don't have a power source on your Mother Board you can use the 4 pin power connectors to connect directly to your Power Supply.

Question 7

Does anyone know if you can use this with a Hyper 212 Evo?

Accepted Answer

I would say no !   I used the plastic ties to rig the 140mm case fan  onto the clips for the 212 EVO.   It will not work well.  Even though the ties will (sorta) hold it the temperature stays too high....no matter what I did.

Question 8

Does this fan use rubber screws/mounts, or tradition screws that require a screwdriver?

Accepted Answer

A screwdriver is required.

Question 9

Does this fan come with 4-pin adapters??

Accepted Answer

Indeed it dose.

Question 10

Will this work with a Cooler Master 430 Black Elite?

Accepted Answer

I purchased the 140mm fan for my HAF 912 case. But the information on the Cooler Master website says the 140mm fan is optional.

This is for the Cooler Master 430 Black Elite:
Cooling System Top: 120mm fan x 2 (optional)
Front: 120mm blue LED fan x 1 (installed),or 140mm fan x 1 (optional)
Rear: 80/90/120mm fan x1(optional)
Side: 120mm fan x 1(optional)
Bottom:80/90/120mm fan x 1(optional)

Questions & Answers