Question 1

I just bought this (CP1000PFCLCD version)

and the full title says "CyberPower CP1000PFCLCD UPS 1000VA / 600W PFC compatible Pure Sine Wave w/ USB Charging Ports"

but the picture of the CP1000 version doesn't show any usb charging ports, only the 1350 and 1500 ones do.

Is that a mistake by newegg?

Accepted Answer

Now I'm very confused. The images for the "CP1000PFCLCD"  "1000VA"  Item Number N,eight,two,E,one,six,eight,four,two,one,zero,two,one,three,two definitely show 1x TypeA and 1x TypeC USB ports on the front, AND the "Specs" section says under the "Details" Heading
"Interface Port: 1 Type A, 1 Type C, 1 Dry Contact"
EVERYTHING claims this has 2x USB ports on the front panel.
(Note: I had to enter the Newegg Item number in alpha because darn system thinks I tried to enter a phone number and wouldn't let me submit it.)

Question 2

Does this UPS condition the power to a true sine wave even when not on battery power? In other words is this a power conditioner/surge suppressor/battery backup in one?

Accepted Answer

Most models are line interactive, which is what that guy is asking, some give the option for standby or line interactive. Their WEB site explains this.

Definitions (from a BLOG): 
Line-interactive - In the consumer world, there are three major types of UPS units: standby, line-interactive, and double conversion ("online"). Standby runs wall power straight to the device with minimal filtering unless it detects a major voltage change. Then it switches to battery. Line-interactive is the same, except with a filtering transformer between the wall and the device to handle most voltage variations. In an area with dirty power, line-interactive units won't cycle to battery power as often. With clean power, there's no practical difference between the two. Double-conversion means the battery always powers the device and wall power only charges the battery. The isolation is helpful for sensitive things, but less efficient because the wall power is perpetually converted from AC to DC and back to AC. The heavy-duty inverter this type requires also tends to increase cost and noise.

Question 3

Does this unit have 5 battery back up plugs and 5 surge protected plugs?

Accepted Answer

Yes it does. Some plugs are a little close, and you're not supposed to plug in a power strip, but for low-power devices running on a strip and large-draw devices plugged in directly it won't matter much.

Question 4

Does it have a fan? Hate fan noise!

Accepted Answer

I do not believe it has a fan.  It is generally perfectly quiet.  When switching to and from battery you do hear the click of the relay.  While on battery you do hear a hum.  There is the alarm, but that can be turned off.

Question 5

I keep seeing versions with and without Coaxial connections. Does this unit have Coax support?

Accepted Answer

Yes - but you would have gotten the answer much quicker had you bothered to look at the pics, description, and specs for the unit on the Newegg website...............................

Question 6

What happens if it is overloaded for a long period of time?

Accepted Answer

I would like to answer your question, but you left out a LOT of facts.
What do you mean by "overloaded"? Do you mean while the mains are on and the all the things you have connected to the AC output exceed the ratings of the unit? Or, do you mean overloaded AFTER the unit has switched to battery power?
However, the answer is probably obvious.  If overloaded on the mains side, the breaker will shut it off.  If overloaded on the output side runningon battery, the battery will discharge and the output will drop out.

Question 7

Is this ups compatable with windows 10?

Accepted Answer

Yes this is compatible with Windows 10.  I'm using one  with Windows 10!

Question 8

I bought this unit and the power panel software disc is for Windows only. How do I get a Mac version?

Accepted Answer

My guess is you would have to go with a "Mac Certified" UPS. Or you can peruse one of the few mac cult sites that offer info on third party software that may work.

Question 9

The unit beeps every 45 seconds, seems for no good reason, all functions seem to be working fine, with good readings on the digital screen, so why the beep?

Accepted Answer

I have this same unit. I don't know why it beeps every 45 seconds. Mine never did that. Try checking the manual for clues. If the unit is working normally though, it is possible to turn off the beep sound. I turned my sounds off as I don't really need to hear it. It's obvious there's a power failure since all the power to the house is gone. It's very annoying when you're asleep too. The unit has memory also so that it won't beep again unless you turn the sound back on. I know since I've had a few power failures and the unit will remember not to beep.

I hope this helps.

Question 10

add says 10 outlets , but I only see 8 ? in picture of back .
JIM

Accepted Answer

There are 2 rows of 5.  It's easy enough to plug a power strip into it if you need more or to move the clutter away from the back of the UPS.  Just watch the total load plugged into it.  This is a good unit, it's worth the investment.

Brand	CyberPower
Series	PFC Sinewave Series
Model	CP1000PFCLCD

International Version	120V
Input Voltage Range	88 - 144V
Input Frequency	57 - 63 Hz
Input Connection	NEMA 5-15P

VA Rating	1000 VA
Watts	600 Watts
Output Voltage	120 VAC +/- 5%
Output Frequency	60 Hz +/- 1%
Outlets	10
Outlet Type	NEMA 5-15R

Battery Type	Sealed Lead Acid
Battery Run Time	Runtime at Full Load: 2 min Runtime at Half Load: 6 min
Battery Recharge Time	8 Hour(s)
Battery Replaceable	Battery Cartridge RB1290

Alarms	On Battery, Low Battery, Overload, Fault
Interface Port	1 Type A, 1 Type C, 1 Dry Contact
Management Software	PowerPanel Personal Edition
Approvals	UL1778, cUL 107.3, FCC DOC Class B, RoHS Compliant

Best Sellers

Sponsored Products

CyberPower CP1000PFCLCD PFC Sinewave UPS Systems - 1000VA/600W, 120 VAC, NEMA 5-15P, Mini-Tower, Sine Wave, 10 Outlets, LCD, PowerPanel®

Learn more about the CyberPower CP1000PFCLCD

Customer Reviews of the CyberPower CP1000PFCLCD

Warranty & Returns

Warranty, Returns, And Additional Information

Warranty

Return Policies

Manufacturer Contact Info

Recommended For

Spec Summary

Data Line Protection	1-in / 1-Out (10/100/1000) + PoE Compatible
Surge Energy Rating	1030 Joules
Protection	Internal Circuitry Limiting Circuit Breaker Protected

Attribute	Value
Best For	Sensitive electronics needing sine-wave battery backup, surge protection, and short-term runtime during power interruptions
Power Capacity And Output	1000 VA / 600 W capacity with 120 VAC output (±5%) at 60 Hz (±1%)
Input And Topology	Line-interactive UPS with 88–144 V input range, 57–63 Hz input frequency, and a NEMA 5-15P plug with a 5-ft cord
Outlets And Connectivity	10 NEMA 5-15R outlets, plus Type-A USB, Type-C USB, and dry-contact interfaces
Battery And Runtime	Sealed lead-acid battery with 2 minutes of runtime at full load and 6 minutes at half load; recharges in 8 hours and uses replaceable RB1290 battery cartridge; stated average battery life is 3 years
Surge And Line Protection	1030-joule surge rating with circuit-breaker protection, internal circuitry limiting, EMI/RFI filtering, and data-line protection with 1-in/1-out Gigabit Ethernet, PoE, RJ11/RJ45, and coax RG6 support
Monitoring And Management	Multifunction LCD panel, PowerPanel Personal Edition software, and on-battery, low-battery, overload, and fault alarms
Compliance And Operating Conditions	UL1778, cUL 107.3, FCC DOC Class B, and RoHS compliant; operating temperature 32–104°F (0–40°C) and storage temperature 5–113°F (-15–45°C)
Physical Design	Black mini-tower with plastic enclosure; 9.10 × 3.90 × 10.20 in and 18 lb
Model Identifiers	CyberPower PFC Sinewave Series, model CP1000PFCLCD

Dimensions & Weight
Dimensions	9.10" x 3.90" x 10.20"
Weight	18 lbs.

Item#: N82E16842102132