
Very easy to install and configure Fits perfectly in Asus AP201 case Keeping my 9950x3d perfectly cool

Great looks Low temps Low noise



Atmos VRM works and looks better than my arctic liquid freezer

Had an Enermax installed that pooped out after 4 years. This installed with ease, and minus a very slight hum, is very quiet. It keeps my temperatures in the low 30s while idling, and in the 40s under load.

Low cost cooling.$40 aio seems to be working good.

Idles at 48c, I have it at an intake at the front of my case and keep the house at 70-71F. Allows the chip to boost fully whilst keeping it around 60-65c at 5.3GHZ. I have seen 80-85c whilst at 100 percent utilization, but it was only for a few seconds.\ Easy to install, just make sure the pump, which is the black rectangle on the 2 lines, is not the highest point in your system, or you will kill your pump super fast, under 6 months. The rgb is very lowkey, I have an all black build expect for the block, and it is a nice touch. The fans are not super loud either, yes they ramp up but if you are using speakers or have headphones on, you will not hear them

Performance




The thing that I'll say first is that the logo plate can interchange in any direction which means it can be installed either vertical or horizontal there are no limits, the white one which i bought goes well in my all white builds but most importantly the installed of this beast on the cpu processor was well equipped with the parts that made it easy breezy, thank-you msi I'm a believer.

- Easy install - Looks very sleek - Display settings are sick! - Cool and Quiet! - Comes with thermal paste pre-applied

Installed and have been using this AIO for a while now and have not had any issues so far. Installation was simple, the instructions were clear with pictures of each step. Installed this cooler over a contact frame holding an i9-14900K CPU. Did not overtighten any screws and applied my own TIM. It booted perfectly fine on the first attempt. In the 5000D, there is space for three fans at the top in 'pull' and three fans at the bottom for 'push' orientation. It idles at about 25-29°C and averages 60-65°C under load and rarely spikes into the 70-80s during gaming or stress testing. BIOS settings are set to default with XMP profile. Comparing this AIO to similar coolers at current prices, this model seemed to be the most cost effective and has good reviews.




