Pros: Excellent Heat Sink. Tons of thin copper shims to dissipate a lot of heat. It pulls a ton of CFM.

Cons: Automatic mode doesn't work as well as I'd hope. The POT that allows you to control the RPM is very nice.

Overall Review: Phy**PowR obviously has a reading problem. There are no confusing wires, the instructions tell you exactly how to install this HSF. It has a molex connection, an rpm sensor, and a 10k thermistor. If 3 wire connections are confusing, Don't purchase this product. Insted buy a brick and bludgen yourself.

Comments: This case looks really great in pictures. The frame however is very thin and very flimsey. I think an aluminum can is stronger than certain areas on this case. The acrylic window is pretty nice, and the front end temp read out is great. For $ this is a good buy. Remember, you get what you pay for. I'd recommend a better quality case, over the bells and do dads.

Comments: This board is great. Only one problem. The 5v jumper setting has the potential to fry your RAM and/or mother board. Be careful with this. I recommend keeping it at 3.3v You can still get a good overclock with that.

Comments: Um... I was disappointed. It looks nothing like the picture. Its simple green ram. As far as the hardware end of it goes... The ram is alright. I didn't get any fantastic speeds out of it. It gets too hot. I'm giong to get some heat shims to see if it cuts down on the temp. For the price, its alright.

Comments: I haven't had many problems with the LED's and Fans, but I have noticed the lucite front to crack and spider. I don't believe its from rough contact with anything, most likely temperature changes.