Pros: Very sturdy. No sharp edges. Easy drive bay access. Easy side removal.

Cons: No CD/DVD. I did not notice that the case does not allow for a DVD drive so my bad on that. Instructions are picture only, no text. While a picture is worth a 1000 words that is true only with good detailed pictures. LED/front fan connections are barely mentioned in the instructions and the picture is barely readable.

Overall Review: Good case. Nice fans with controllable LED's.

Pros: Put WD 6 TB drive into it to make a RaspberryPi boot drive/Plex Server. Everything is working great. Good construction. Easy assembly.

Cons: Would like an option to mount flat. Will have to see if the drive has issues being mounted on its side.

Overall Review: .

Pros: Using for my Home Assistant zigbee gateway (about 3 months). All Zigbee items are found without problem. Steady and reliable connection. Using plugged straight into my Raspberry Pi in my IT closet. Have never had any interference issues.

Cons: None

Overall Review: Would definitely recommend as a Zigbee gateway for Home Assistant,

Pros: Worked most of the time as advertised

Cons: Would occasionally drop off the Zigbee mesh. Never extended the mesh network. I have heard since I bought this that Aqara devices (which most of my Zigbee components are) actively fight other brands on the network especially if run through an Aqara hub (mine is not). The 2 plugs I have are in non-critical uses now in case they get killed by Aqara.

Overall Review: Decent product. Just watch what devices are on your network.

Pros: Works with well home assistant Good response time for adjustments Bright Dimable

Cons: Mediocre colors control. The straight colors (red, blue, and green) are not perfect. Leads to slightly off colors.

Overall Review: Used as accent lights. Working great in my home automation setup in Home assistant.

Pros: Keeps Pi4 at 32 C when overclocked, in a case, and stress tested for 10 minutes. Fit perfectly. Pretty quite. LED is rather bright and pretty.

Cons: Mounts cannot work on CM4 module. Have one that I had to 3D print a mount for the CM4 module. Keeps it at 32 C always. Fan is single speed (select fan speed by plugging into 3.3V or 5V pin on GPIO. LED is rather bright but I haven't found a way to shut it off. None of the base level cases will work. Find a 3D printed case for it.

Overall Review: If you stress your Pi out you NEED one of these.