Rechargeable Motion Sensor Ceiling Light Magnetic Mount
In the motion sensor mode, you can slide the slider to set the timer to 15 seconds, 30 seconds or 60 seconds
3 Color Temperatures and Stepless Dimming
120° Sensing Angle and Beam Angle
Magnetic Installation: Tear off the double-sided tape and stick it on the back of the iron sheet, and stick the other side on the surface where the lamp is installed, then adsorb the lamp on the iron sheet, or you can directly adsorb the lamp on the metal surface
Screw Installation: You can fix the screws and iron sheet in the package on the surface by drilling holes, and then adsorb the lamp on the iron sheet for use
Screw Wall Mounted: There is a hanging hole on the back of the lamp. You can drill two holes with a horizontal spacing of 3.15 inches (8CM) on the wall, then fix the screws and hang the lamp on the wall surface for use
Note: please fully charge before first use
Applicable to a variety of common application scenarios:
User Notice
You can use the remote control to control the light switch, brightness, color temperature and induction mode. You can also set a 30-minute or 60-minute timer. After pressing the timer button, the first flash is a 30-minute timer, the second flash is a 60-minute timer, and two consecutive flashes are turn off timer. After turning on the timer function, you can turn off the timer by pressing any button. The remote control uses two AAA batteries (not included)
Rechargeable Motion Sensor Ceiling Light Magnetic Mount
In the motion sensor mode, you can slide the slider to set the timer to 15 seconds, 30 seconds or 60 seconds
3 Color Temperatures and Stepless Dimming
120° Sensing Angle and Beam Angle
Magnetic Installation: Tear off the double-sided tape and stick it on the back of the iron sheet, and stick the other side on the surface where the lamp is installed, then adsorb the lamp on the iron sheet, or you can directly adsorb the lamp on the metal surface
Screw Installation: You can fix the screws and iron sheet in the package on the surface by drilling holes, and then adsorb the lamp on the iron sheet for use
Screw Wall Mounted: There is a hanging hole on the back of the lamp. You can drill two holes with a horizontal spacing of 3.15 inches (8CM) on the wall, then fix the screws and hang the lamp on the wall surface for use
Note: please fully charge before first use
Applicable to a variety of common application scenarios:
User Notice
You can use the remote control to control the light switch, brightness, color temperature and induction mode. You can also set a 30-minute or 60-minute timer. After pressing the timer button, the first flash is a 30-minute timer, the second flash is a 60-minute timer, and two consecutive flashes are turn off timer. After turning on the timer function, you can turn off the timer by pressing any button. The remote control uses two AAA batteries (not included)