Question 1

anyone want to weigh the lancool II performance? I know most people probably already have it fully built, but even the weight of it built would be nice since I can't find numbers anywhere by the manufacture.

Accepted Answer

I had the same question. I looked all over Newegg and all over the Lian Li site, couldn't find the answer. I received this case today (Performance) and weighed it. 26 lbs.

Question 2

Will an MSI GeForce GTX 1660 Super Gaming X Graphics Card fit in this case?  Actually want to put two in.  Thanks!

Accepted Answer

I will answer your question,  currently running RTX 2070 it fits however since you have indicated your intent to run two cards  #1 I would first consider your coolers dimension to make sure it does not cover your first 4.0 slot(Air Cooled) since your intending on running a SLI configuration.  #2  Its and ATX Motherboard so its pretty tight and may hinder your other cards from fitting,  IE sound cards or other proprietary cards for example. # 3 oh the heat!!!!,  although this case is better with Thermals be careful again with this case because extreme creativity is required to pull off elaborate liquid cooled configurations with two SLI cards.   Anything positive can happen if you consider the design.

Question 3

Would an Arctic Liquid Freezer II 360mm fit in the front? I know the radiator is thicker than other AIO so wasn't sure if it will.

Accepted Answer

Yes, look at the specs on the manufacturer's site. The Lancool 2 has a multi-way rad/fan bracket. 360mm support.

Question 4

Does it has fan bracket or can you directly put two fans at the top and two fans at bottom? Do i need to buy fan bracket seperately?

Accepted Answer

The two available fan positions are installed directly to the case. The two fan positions on the bottom are secured by two screws each and installed directly on the case.

Question 5

How many fans does it have and what are the fans 120mm or 140mm?

Accepted Answer

It comes with 3 pre-installed case fans. The front 2 are 140mm and the rear is 120mm. It's whisper quiet and keep really good temps with just the 3.
I would add 2 120 top exhaust fans if you're going to add more though you don't really need it. It would probably raise the noise level a bit, especially if you buy cheaper fans for those slots.

Question 6

Will the case fit a Kraken X63? Its a 280 mm aio and I'm planning to mount it to the top

Accepted Answer

You cannot install a 280 mm on the top, only a 240 mm. I have a 280 mm installed in the front.

Question 7

I was wondering if the case will fit a NZXT kraken x63? It's a 280 mm AIO and I'm planning to mount it to the top of the case

Accepted Answer

Only a 240 mm on top.

Question 8

the included fan hub can be connected to MB header instead of the built in controller?

Accepted Answer

Yes it has the ability to connect to the motherboard for PWM control.

Question 9

the included fan hub can be connected to MB header instead of the built in controller?

Accepted Answer

Either or. It has four positions, low, medium, high and PWM. Use the fan hub for the optional bottom fan positions only.

Question 10

What is the wattage of the LED's at the front of the case?

Accepted Answer

There are no leds on the front of the Mesh performance. Only one white LED on the power switch.

Questions & Answers