Adjustable Plastic Wall Mount Bracket Kit for Router Modem DVR | Holds CCTV, DVR and NVR recorders, routers, network switches, modems, cable boxes, mini PCs and Freeview receivers

One mount, three parts. This is a single mounting system, not three separate mounts. Two clamps sit beneath the device and take its weight. The third sits above and holds the top edge back against the wall, so the device stays flat and secure.

You set the width. Because the two lower clamps mount independently, you decide how far apart they go. Spread them wide for a long router or a set-top box and the device is supported across its full length. A fixed-width bracket cannot do that.

Will it fit? Measure the thickness of your device. The jaws close down onto anything up to 2.1 inches (54mm) thick. Three plastic spacers are included for slimmer boxes, so one kit covers everything from a thin switch to a full-depth modem.

Wall, cabinet or under the desk. The brackets screw to any flat surface in any orientation. Mount a router on a hallway wall, a switch inside a cupboard, or a media box upside down under a desk to free up the desktop.

Typical uses:

- Routers, modems and mesh nodes

- Network switches and patch gear

- CCTV DVRs and NVRs

- Set-top boxes and streaming boxes

- Mini PCs and small form factor desktops

- Games consoles and AV kit

In the box: 3 x plastic brackets with plastic adjustment screws, 3 x plastic spacers, 3 x wall screws with wall plugs.

What it is made of. These are plastic brackets, precision 3D printed in the UK from a tough engineered polymer. They are light, they will not corrode, and they are intended for light electronic equipment - not for televisions or heavy hardware.