Product parameters:
Input: DC12-24V.Output: DC5V/3000MA.
Material: ABS+PC.Wire specification: The wire length is 3.5 meters.(11.5ft).
Wire diameter OD: 4mm.Low voltage protection: 12V car-11.6V; 24V car -23.6V.
Connector type: USB TYPE-C.
If you forget to start/stop the dash cam, it will automatically start/stop.
Simply plug in the OBD plug to power your device. It will not interfere with any vehicle diagnosis.
90 ° angle design: The USB plug adopts a right angle design, which is very suitable for saving space and connection in narrow spaces.
Scope of application:
The MEIRYFA OBD OBD2 power cord is widely compatible with most fuel powered vehicle recorders, GPS, radar, mobile phones, and dash cams; It is not suitable for electric and plug-in hybrid new energy vehicles. Two modes: The "O" symbol for the switch is ACC mode (power supply for car startup, power off for car shutdown). The symbol for switch "one" is in constant power mode (24-hour parking monitoring).
Constant power mode [press switch "?"]: 24-hour parking monitoring. After the car is turned off, the output ACC signal is turned off, and the positive pole continues to supply power.The recorder enters the delay recording function until the car's battery level drops below 11.6V. After a delay of 5 minutes, the OBD line will automatically stop supplying power!
ACC mode [press switch 'O']: When the car is turned on and powered on, the OBD circuit will automatically stop after a 20 minute delay when the car is turned off.
Product parameters:
Input: DC12-24V.Output: DC5V/3000MA.
Material: ABS+PC.Wire specification: The wire length is 3.5 meters.(11.5ft).
Wire diameter OD: 4mm.Low voltage protection: 12V car-11.6V; 24V car -23.6V.
Connector type: USB TYPE-C.
If you forget to start/stop the dash cam, it will automatically start/stop.
Simply plug in the OBD plug to power your device. It will not interfere with any vehicle diagnosis.
90 ° angle design: The USB plug adopts a right angle design, which is very suitable for saving space and connection in narrow spaces.
Scope of application:
The MEIRYFA OBD OBD2 power cord is widely compatible with most fuel powered vehicle recorders, GPS, radar, mobile phones, and dash cams; It is not suitable for electric and plug-in hybrid new energy vehicles. Two modes: The "O" symbol for the switch is ACC mode (power supply for car startup, power off for car shutdown). The symbol for switch "one" is in constant power mode (24-hour parking monitoring).
Constant power mode [press switch "?"]: 24-hour parking monitoring. After the car is turned off, the output ACC signal is turned off, and the positive pole continues to supply power.The recorder enters the delay recording function until the car's battery level drops below 11.6V. After a delay of 5 minutes, the OBD line will automatically stop supplying power!
ACC mode [press switch 'O']: When the car is turned on and powered on, the OBD circuit will automatically stop after a 20 minute delay when the car is turned off.