Specification:3-pole battery isolation solenoid valve: Voltage: 12VDC; Working current: Below 80A Resistance: 14; Capacity: 10.2W; Maximum transient flash current: 200Amp; Contact stud: 5/16-24 stud standard and Long; Mounting Holes: 5/16 x 19/32, 2-13/64 Center.
High Quality:The coil uses 180 copper wire, the electromagnetic relay is made of high-quality components,the contact: normally open (NO), the galvanized outer layer and the inside of the canned coil, suitable for use in any environment,Sealed Unit Protects Solenoid From The Elements Helping Prevent Corrosion.
Application:Wiedly Used for Marine, Winch, Military Vehicles, Hydraulic Control Units, Golf Cart, Factory Machines. Attention: If it is the energizing circuit which is typically 16/18 Awg, suggest a 5amp fuse; If 10 Awg wire suggests 30 amp auto circuit breaker; If high output alternator, suggest an 8 AWG wire with a 50 Amp auto circuit breaker.
INSTIALLOne side goes to Battery, opposite side to starter, top screw which is smaller goes to switch or key start only. It is already grounded internal.