Hantek Accessory Set 10MHz Bandwidth 20:1 Attenuator with HT30A Auto Test Cables (30A+2 x 201)

HT30A: A special line for assisting automobile measurement instruments to test various types of signals. It consists of wide range probes, clips, gators can be plugged into the 4 mm connectors at the end of the cable
HT30A: 3M BNC to banana adapter cable, heavy duty auto test lead. Allowing the oscilloscope away form the car being tested or repaired and placed on the bench
HT30A: To avoid the lines twisting together, the 2 connectors has different length. The short line is earth wire, and the long line is positive pole which should be connected with the auto engine cable
HT201: HT201 Attenuator designed for assisting automobile measurement. Passive attenuator with 20:1 attenuation, if input a 20V signal, it can output a 1V signal. Bandwidth: 10MHz
HT201: The HT201 has been designed to allow fuel injector and primary ignition waveforms to be measured using Hantek oscilloscope products. Please note this attenuator should not be used for any high voltage measurements other than fuel injectors and primary ignition
This oscilloscope accessories set suitable for auto measurement, it work better when used together, it meet your various demand of your oscilloscope test