WOLFBOX USB C Hardwire Kit OBD, Hard Wire Car Charger Cable Kit 12V-24V to 5V, Avoid Dash Cam Battery Drain, Suitable for G840S/G930/G840H/G850/G850PRO/X5/i07/i17/X3 Dash Cam

Wide Capacity - hardwire kit for WOLFBOX dash cam or other device powered by Type-C port, 5V/3A steady output, voltage input supports from 12V-24V
High Compatibility - The OBD step-down line can supply power to most of the car electronics (except for Tesla), plug and play, without damaging any car circuits, and the anti-interference does not affect the normal operation of other devices
Installation Location - The most common location of the car OBD interface for the driver is the lower left of the trim panel under the steering wheel. However, the location of the OBD will be slightly different depending on the origin and model year of the vehicle. Some are above the accelerator pedal, or near the driver' s side fuse box, some are in front of the shift lever, etc. Please choose the most suitable location for installation
Connect and Setup - Connect the OBD hardwire kit to the vehicle OBD interface, and connect the Type-C USB to the dash cam. Then start the car, turn on the dash cam, and set the parking monitor mode
Low Voltage Protect - Multiple Security Protection - With low voltage protection, When the car is turned off the voltage below 13V the recording will continue within 5 minutes, and the power will be turned off after 5 minutes