LILYGO T-Deck ESP32-S3 LoRa BLE WiFi TTGO Module LoRaWAN Long Range Development Board (Black LILYGO Firmware)

Product description Product Display T-Deck

Specifications

For more programming information about the product, please refer to
Github: github. com/Xinyuan-LilyGO/T-Deck T-Deck can't upload any sketchPlease enter the upload mode manually. Connect the board via the USB cable Press and hold the BOOT button, While still pressing the BOOT(On the trackball above the keyboard, press down) button Press RST button Release the RST button Release the BOOT button Upload sketch Pin Diagram If a microphone is used, the GPIOO button cannot be used If the sketch cannot be uploaded, then you need to press down the middle of the trackball, and then insert the USB, this means the chip is in the download mode, and then click to upload the sketch. T-Keyboard the programming and burning interface of ESP32C3 is located at the 6Pin header on the side of the RST button, and the order starts from the top of the RST button, which are 3V3, GND, RST, BOOT, RX, TX, You need to connect USB TO TTL externally to burn the keyboard firmware. For TTL without automatic download circuit, before powering on, short-circuit the BOOT Pin and GND, and then power on. At this time, T-Keyboard will enter the download mode.

After the burning is completed, you need to disconnect GND and BOOT before running the program. shipping list 1 X T-Deck(Black Keyboard 1 X Pin (6pin) 1 X Power cable 1 X 433/868/915MHz LTE antenna