Your Browsing History
- Free 30-day Returns
$26.79
Meet Your Seller
ASI 388 Clear Electronic Grade Silicone - 10.2 oz Squeeze Tube
- Container size: 10.2 Oz. This electronic grade silicone is a one-part, moisture- curing RTV (room temperature vulcanizing) silicone sealant/adhesive that is non-slump and cures to form a tough, permanently flexible rubber.
- The non-corrosive curing system of this electronic grade silicone makes it ideally suited for protecting, sealing and insulating corrosion-sensitive electronic and electrical materials such as copper, brass, silver, etc.
- Specifically formulated for use in electrical/electronic production and assembly.
- This electronic grade silicone is a neutral-cure silicone that emits no objectionable odors during cure and is ideally suited for use in confined areas. However, adequate ventilation should be provided when used in large-scale production.
- 100% silicone and has excellent resistance to temperature changes from -57 C to +204°C (-70°F to +400°F)
+
+
Overview
Specs
Reviews (4)
Any questions? Our AI beta will help you find out quickly.
Try me now
SURFACE PREPARATION
All surfaces should be clean and dry. It is recommended that bonding surfaces be solvent wiped with oil-free solvents, such as xylol, toluol naphtha or non-flammable chlorinated solvents. Do not wipe with oil-based solvents such as Varsol. Allow surface to dry thoroughly before applying sealant.
DIRECTIONS
This electronic grade siliconeKEY_TAB is ready to use and requires no mixing or additives. The cure mechanism begins as soon as the sealant comes in contact with the air. At conditions of 25 C (77° F) and 50% relative humidity, the sealant will skin in 15 minutes and fully cure within 48 hours (1/8 bead).
Higher humidity accelerates cure. Tooling should be done before skinning takes place.
In applications where partial total confinement of sealant is prevalent, the time required for proper cure is lengthened by the degree of confinement.
PRIMING
Priming of the electronic grade siliconeKEY_TAB is normally not required for application to most substrates.
Unprimed adhesion can be readily tested by applying a small trial bead and allowing 7 days for maximum adhesion to occur.
Warranty & Returns
Warranty, Returns, And Additional Information
Warranty
- Please contact the Seller directly for warranty information. Warranty information may also be found on the Manufacturer's website.
- CONTACT
Return Policies
- Return for refund within: 30 days
- Return for replacement within: 30 days
- This item is covered by SatelliteSale Return Policy
Manufacturer Contact Info
- For a directory of all our manufacturers, please click below.
- Manufacturers Directory
LOADING...