6.56ft COB LED Strip Light 6 Rolls of 3000K Flexible COB LED for Acoustic Panel and Wood Slat Wall Panels Parallel with Dimmable Touch Sensor Switch Cuttable for Wood Slat Lighting Shelf

6 Rolls of Flexible COB LED Strip Light in
Parallel: 6 rolls of 3.28 ft/ 6.56 ft/ 9.84 ft cob led strip installed in parallel and controlled by a single sensor the number of light beads is dense ensuring high brightness and low energy consumption creating a warm and inviting environment led lights for wood slat wall panels acoustic panels lighting display case gun safe lighting under cabinet lighting kitchen lighting and shelf lighting other indoor scenesTouch Sensor Switch and
Dimmable led strip lights: The sensor comes with adhesive stick the sensor on the partition ( 2 cm/ 0.8 in) you can control the cob led strip light 12 v by touching and hand-scanning a short press can control the cob led strip light to turn on and off a long press can adjust the brightness of the led strip warm white very convenient. Meanwhile the sensor has a memory function which saves your time to reset (without unplugging the plug) Hidden sensor switch no need to punch holes: The sensors are suitable for wood slat wall panel acoustic panel shelf lighting fluted panels cabinet lighting and others that need to be fitted with hidden sensor switches that you can stick to the back of wooden partitions without opening any holes! The thinner the partition the higher the sensitivity of the control. It is recommended that the control area of the partition is within 0.8 in. Keep them away from metallic materialsSelf-adhesive & Cuttable led strip lights
COB: cob light strip comes with adhesive backing installation is more convenient and concise. Please wipe the surface to be installed before installing the light bar so that the adhesion is better. The strip can be cut along the center line of the 2-pin copper piece (every 2cm/ 0.8 in) you can cut it according to the installation requirements. This led panel lights can meet your needs for installation on sound-absorbing panels and wood slat wall panelPlease note: Do not install the sensor on metallic materials to avoid interference. For higher sensitivity a partition thickness of 2 cm/ 0.8 in is recommended. When cutting cut along the center line of the 2-pin copper sheet and disconnect the power supply before cutting. Please do not stick the backing material repeatedly so that the adhesion of the adhesive does not weaken