Bus Servo Controller Serial Bus Servo Tester Board for Bus Servo

Support PC graphical debugging and TTL serial port communication.
This controller is compatible with /Lewansoul bus servo.

Product Description

intelligent serial bus servo controller can be used in serial servo control and it can combine with PS2 wireless handle to realize servo remote control. It supports manual programming, online debugging and TTL serial port communication. If you are using serial bus servo of 11.1V, like LX-224HV, 824HV, etc, please use 11.1V lithium battery to power the servo.

Feature

• 16M high-capacity memory, which is able to hold 230 action groups! Each action group can hold up to 510 actions!
• CPU uses high-performance STM32 single chip microcomputer with ARM Cortex-M3 corer.
• Support online debugging, no need computer drive.
• Support PC graphical debugging and TTL serial port communication.
• The controller will alarm if low voltage occurs.
• Only applicable to serial bus servos.

About Wiring and PC Software Interface

This product is independently developed by ourselves. We donot provide a schematic diagram or any source code, Offer a complete set of communication protocol and communication baud rate of 9600 to help your secondary development. Please note that schematic diagram and source code are not provided.

Rotate the screwdriver

counterclockwise to loosen the screw.

Insert the battery pairing wire into the power interace. Insert red wire into + and black into "-". Then fix them with screwdriver.

Connect the other end of pairing wire to black port of the battery.

Please press two convex slots slightly to take off the battery. Do not pull the wire violently.

1. Lithium battery wiring

2. Lithium battery wiring

3. Lithium battery wiring

4. Lithium battery wiring