12+8 Programming Bypass Cable for FCA SGW Module, OBD2 Diagnostic Adapter Connector Compatible with Autel DS808, MaxiSYS MS906, MS908 PRO, MaxiSYS Elite Car Scan Tools

This professional 12+8 SGW bypass programming cable is specially developed for Autel MaxiSYS series diagnostic tools, solving the secure gateway access restriction on post-2018 FCA vehicles including Chrysler, Jeep, Dodge, Ram and Fiat models.

The cable features one standard 16Pin OBD2 male plug to connect your Autel scanner, split into independent 12Pin and 8Pin male terminals that directly plug into the vehicles internal SGW gateway wiring harness. It fully bypasses the security lock of factory gateway modules, allowing your scan tool to unlock advanced functions blocked by standard OBD2 ports.

Compatible perfectly with Autel DS808, MaxiSYS MS906, MS908 PRO and MaxiSYS Elite car diagnostic systems, this adapter supports complete vehicle operations: ECU reprogramming, immobilizer key matching, bidirectional actuator tests, mileage calibration, full fault code reading & clearing, live data streaming and special function reset.

Built with thick anti-interference shielded copper wire and high-strength ABS red connector housings, each joint is equipped with flexible strain relief to prevent wire cracking after frequent plugging and unplugging in repair shops. All metal pin terminals adopt gold-plated treatment to maintain stable signal transmission without dropouts during long-hour programming work.

No complicated configuration or driver installation required. Just disconnect the original vehicle 12+8 gateway plugs, connect them to this adapter, then link the OBD2 end to your Autel scanner to start full-depth vehicle diagnosis instantly. Essential workshop accessory for auto repair technicians handling modern FCA-platform cars.