12V 100Ah LiFePO4 Solar Battery Deep Cycle Lithium Battery for Solar Systems, Off-Grid, RV, Marine, and Backup Power with 15000+ Cycles, Lightweight, Maintenance-Free

Reliable 12V Solar Battery for
Solar Systems: This 12V 100Ah LiFePO4 solar battery is designed specifically for solar systems, whether youre off-grid or seeking reliable backup power. Compatible with solar panels ranging from 200W to 400W, it efficiently stores solar energy for later use, making it ideal for homes, cabins, and RVs running on solar power.
Long-Lasting,
Deep Cycle Performance: The 12V 100Ah LiFePO4 battery offers over 15000 deep cycles, making it a perfect solar battery for solar panel setups. Whether you' re using it for daily solar charging or as backup power in off-grid environments, this solar battery will ensure steady power output for years.
Lightweight and Maintenance-Free 12V Solar Battery: This 12V solar battery is 50% lighter than traditional lead-acid batteries, allowing you to easily integrate it into your solar systems, RVs, and boats. The LiFePO4 technology ensures that your solar battery requires no maintenance, so you can focus on enjoying consistent power from your solar panels without the hassle.
Versatile Solar Battery for Various Applications: Whether you' re powering a solar system for your RV, marine electronics, or using it as an emergency solar battery backup, this 12V 100Ah LiFePO4 battery adapts to your needs. Perfect for off-grid solar systems, it provides reliable energy storage for a variety of solar setups and outdoor applications.
Battery Capacity / Low Power Troubleshooting Guide Use a dedicated 14.4V LiFePO4 charger; avoid lead-acid mixed chargers. Charge continuously until full, then discharge completely, repeat 23 cycles to activate full capacity for new batteries. Check Load Discharge Current Limit Confirm your device working current does not exceed the batterys maximum continuous discharge current. Excess current triggers BMS power protection, resulting in insufficient output. BMS Protection Reset Operation Disconnect all load and charger wires, leave the battery static for 30 minutes, then reconnect and recharge fully to reset the BMS protection board.