EV2400 Mini HPA500 Bqstudio Debugger for 2300 DJI UAV Battery Repair SMB Communication Box T16 T20

Features:
1.Support IIC, SMBUS, and HDQ communication. PORT1, PORT2, PORT3, PORT4, and PORT5 can be used
2. Three-color status lights indicate three states (power supply, communication, USB data)
3. Support for subsequent firmware upgrades, and support for unreleased chips
4. Directly use an USB data cable to complete the communication with a computer
5. Small size, easy to carry
6. 3.3v reference power supply can be provided externally
7. The output pin is pulled up, no external pull-up resistor is needed
8. Electrostatic protection
9. USB port prevents backflow
10. 128Flash + 8RAM + 2USB memory, will not overflow
Attention:
When debugging batteries normally, only VSS, SDA and SCL need to be connected, and Vout is disconnected. Vout is used when there is no battery. Do not connect VOUT when connecting a battery. Do not turn on the battery when debugging the battery to prevent accidental short circuit.
When EV2400 is connected to the computer for the first time, it will self-check and activate automatically. It takes about 1 second without user operation. After activation, install and open the bqstudio software to identify the device and firmware version.
Package Included:
- 1 x EV2400 Mini
- 1 x USB Data Cable
- 2 x KF2510 Connection Cables
Note:
- Batteries are not included.
- It can solve most battery software problems, but it is not for battery hardware failures. Some models, such as battery motherboard for DJI t16, have an MSP430 microprocessor attached to it. After an unreasonable power failure, this processor is very easy to burn and damage the battery. This damage is irreversible and the processor cannot be replaced.