F1T-D2I FT232RL USB to DB9 Male RS232 Serial Adapter Converter Cable Support 7/8/10 Linux

F1T-D2I FT232RL USB to DB9 Male RS232 Serial Adapter Converter Cable Support 7/8/10 Linux
This cable is a USB to RS232 serial converter cables incorporating F1T-D2I FT232RL USB to Serial UART interface IC device which handles all the USB signalling and protocols.
Material: P-V-C
Cable: Round cable, bare copper
Color: black
Cable length: 6FT/1.8M, other length can be made.
Connector A: USB 2.0 TY>pe A Male, plated contacts, connecter
Connectot B: DB9 Male connector
Chipset: F1T-D2I FT232RL
Level: RS232
Molding: P-V-C material, complaint
Testing: 3 times electrical inspection, appearance inspection
Package: PE Bag
About F1T-D2I FT232RL
The FT232RL is a USB to serial UART interfac with the following advanced features:
Single chip USB to asynchronous serial data transfer interface.
Entire USB protocol handled on the chip. No USB specific firmware programming required.
Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.
Fully integrated USB termination resistors.
Fully integrated clock genertion with no external crystal required plus optional clcok output selection enabling a glue-less interface to external MCU or FPGA.
Data transfer rates from 300 baud to 3Mbaud (RS422, RS485, RS232) at TTL levels.
128 byte receive buffer and 256 byte transmite buffer utilising buffer smoothing technology to allow for high data throughput.
F1T-D2I's royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers the requirement for USB driver development in most cases.
USB FTDIChip-ID feature.
Configurable CBUS I/O pins.
Transmit and receive drive signals.
UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity.
FIFO receives and transmits buffers for high data throughput.
Synchronous and asynchronous bit bang interface options iwth RD# and WR# strobes.
Device supplied pre-programmed with