FENG GUO F/;TD/;1 CHIP 4 Port USB to Serial RS232 DB9 Adapter Cable

F/;TD/;1 CHIP 4 Port USB to Serial RS232 DB9 Adapter Cable
Features:
Convert USB standard ports to 4 x RS232 DB9 serial interface
Fully compliance with USB specification 1.1
Compatible to equipment with standard RS232 serial interface
Support over 1Mbps data transfer rate
Supports automatic handshake mode
Supports remote wake-up and power management
Compatible 98/CE/2000/XP/7/8/10 Linux, Ap's M OS v9.0 or higher
USB full speed communication and bus powered low power consume
Driverdownload: www.ftdichip.com

Package : 1 X F/;TD/;1 4 PORT USB TO RS232 DB9 SERIAL MALE CABLE

Compatible driver installation, please refer to
//www.ftdichip.com/Documents/InstallGuides.htm

FT4222H
is a USB2.0 to Quad-SPI/I2C
interface Device Controller with
the following advanced features:
.Single chip USB2.0 Hi-speed to SPI/I2Cbridge with a variety of configurations
.Entire USB protocol handled on the chip
.
.On-chip OTP memory Compatible USB Vendor ID (VID), Product ID (PID), device seria
l number, product description string and various other vender specific data.
.Configurable industry standard SPI Master/Slave interface controller
.Support configurable data width with single, dual, quad data width transfer mode
in SPI master
.SCK can support up to 30MHz in SPI master
.Up to 53.8Mbps data transfer rate in SPI master with quad mode transfer
.Support single bit data transfer with full-duplex transfer in SPI Slave
.Support up to 4 channels slave selection
control pins in SPI master application
.Configurable I2C Master/Slave interface controller conforming to I2Cv2.1 and v3.0 specification

.Support
4 speed modes as defined in the I2C-bus Specification,standard mode (SM)
up to 100K bit/s, fast mode (FM) up to 400K bit/s,
Fast mode plus (FM+) up to 1Mbit/s, and High Speed mode (HS) up to 3.4 Mbit/s
.Confi