IPCamPower's POE Combiner and Splitter. A must have for all IP Camera Installers.
Setup is Easy!
Simply Plug the Combiner Unit into a POE Switch or POE NVR
This works on any standard POE Switch or POE NVR. Simply plug it in with no IP configuration needed. Your switch or NVR will "think" you are using 2 cables.
This combines the 2 ports of POE and Data into 1 cable.
The special Combiner unit then takes the 2 cables from the POE switch or POE NVR and combines the data and POE power into one cable. You entire cable run between the POE Switch/NVR and Cameras should not exceed the standard 330' allowable by a standard network run.
Then at the camera end, the splitter will split out the POE and Data into 2 shorter cables.
The splitter unit will be installed near your cameras and it takes the combined POE power and Data and splits it back out to 2 cables again.
The finished product is simple and effective.
The finished product is a simple yet effective solution that will save you time and money in your next IP Camera installation.
A Typical IP Camera Installation using a single Cable for all Cameras.
With a typical IP Camera installation, you would make a home run cable run from the POE Switch or NVR to each camera. While this is still recommended for alot of applications, what if you had areas in which you had 2 cameras side by side? Wouldn't it be nice if you could run one cable to manage both of these cameras?
An IP Camera Installation using IPCamPower's POE Combiners and Splitters
Using IPCamPower's POE Combiners and Splitters, you significantly reduce cable and labor costs by just running one long cable to the areas in which you have 2 cameras side by side.
IPCamPower's POE Combiner and Splitter. A must have for all IP Camera Installers.
Setup is Easy!
Simply Plug the Combiner Unit into a POE Switch or POE NVR
This works on any standard POE Switch or POE NVR. Simply plug it in with no IP configuration needed. Your switch or NVR will "think" you are using 2 cables.
This combines the 2 ports of POE and Data into 1 cable.
The special Combiner unit then takes the 2 cables from the POE switch or POE NVR and combines the data and POE power into one cable. You entire cable run between the POE Switch/NVR and Cameras should not exceed the standard 330' allowable by a standard network run.
Then at the camera end, the splitter will split out the POE and Data into 2 shorter cables.
The splitter unit will be installed near your cameras and it takes the combined POE power and Data and splits it back out to 2 cables again.
The finished product is simple and effective.
The finished product is a simple yet effective solution that will save you time and money in your next IP Camera installation.
A Typical IP Camera Installation using a single Cable for all Cameras.
With a typical IP Camera installation, you would make a home run cable run from the POE Switch or NVR to each camera. While this is still recommended for alot of applications, what if you had areas in which you had 2 cameras side by side? Wouldn't it be nice if you could run one cable to manage both of these cameras?
An IP Camera Installation using IPCamPower's POE Combiners and Splitters
Using IPCamPower's POE Combiners and Splitters, you significantly reduce cable and labor costs by just running one long cable to the areas in which you have 2 cameras side by side.