USB Motion Controller (UC100) with 6ft USB Cable

The UC100 motion controller overcomes the problems Mach3 software experiences with outdated technology and lagging G-code by removing all time critical tasks from the control computer and Windows and executing all these tasks on inside it's own high speed DSP control chip outside the PC. The UC100 controller connects to the PC via the USB port and this kind of port is more modern as an LPT port and exists on all today's computers. The UC100 has a look as if it was a simple USB to LPT port converter module, but it is much more than this. The UC100 is the result of a 2 years hard development and testing cycle and it implements linear and arc interpolation routines with trajectory planner, communication routines, limits and homing functions handling and it has nearly all the functions (with some limitations) as what Mach3 supports with the LPT port driver. Item Specifics 1 - UC100 1 - USB-A to Mini-B cable (6ft), Same pinout as a standard LPT port, Automatic firmware checking and firmware update., Motion control on up to 6-axis (X, Y, Z, A, B, C), Communication buffer: ~1 sec, Sink/source capability: 20mA max. per output, Compatible with UCCNC, Mach3, and Mach4 softwares