Rode PodMic Dynamic Broadcast Microphone Boom Arm Bundle with StreamEye BOOMARM1 27-Inch Aluminum Arm and 10-Foot Balanced XLR Cable Cardioid, Internal Pop Filter, No Phantom Power

PODMIC BOOM ARM STARTER, MIC + ARM +
XLR CABLE INCLUDED: The PodMic ships with the microphone and integrated swing mount and nothing else no arm, no cable. This bundle adds the StreamEye BOOMARM1 27-inch boom arm with 2.8 lb capacity and a balanced 10-foot XLR cable. Three components, one purchase. Add an audio interface and a pair of headphones and you' re recording. The fastest path from order to first take.
BROADCAST RADIO SOUND IN AN UNTREATED ROOM: Most condenser microphones pick up the keyboard, the fan, and the dog because they' re built for treated studios. The PodMic' s tight cardioid dynamic capsule needs you 1 to 4 inches off the grille and that proximity rejects everything else. End-address dynamic capsule, 20Hz to 20kHz with the broadcast-warm midrange that flatters spoken voice, 320 ohm output to a real interface. Record voice that sounds like an FM radio podcast, in a bedroom, with no acoustic panels on the walls.
INTERNAL POP FILTER AND INTERNAL SHOCKMOUNT BUILT INTO THE BODY: Most broadcast mic setups require a separate gooseneck pop screen and an external shockmount cradle. The PodMic does not. Dual-mesh housing absorbs plosives before they reach the capsule no pop screen blocking the on-camera shot. The capsule is internally suspended on the swing mount and the swing mount is internally decoupled from the body desk thumps and arm-adjustment noise stay out of the recording. Two accessories you' d otherwise add, already inside this body.
STREAMEYE BOOMARM1 SOLVES DESKTOP POSITIONING WITHOUT A FLOOR STAND: The PodMic weighs 865 g heavy enough to demand a real boom arm, not a desk tripod. The BOOMARM1 is built for that load. 27 inches of horizontal reach, 2.8 lb capacity, aluminum alloy with external tension springs that adjust quietly. Detachable universal mic clip fits the PodMic. Desk clamp fits edges up to 2.95 inches thick. Included 3/8 and 5/8 inch thread adaptors keep the arm compatible with any future broadcast or condenser mic upgrade.
BALANCED XLR PATH WITH COMMON-MODE REJECTION: The signal chain matters as much as the mic. The included 10-foot XLR cable is balanced 3-pin male-to-female with full shield common-mode rejection eliminates hum, buzz, and RF interference across the entire run. Long enough to route through cable management to a desk-mounted or shelved audio interface; short enough not to coil into the recording space. The detail you don' t think about until a longer unshielded cable picks up your monitor' s switching power supply.