






Any questions? Our AI beta will help you find out quickly.
32000W Peak 8000W (4000W 110V Or 4000W 220V)
Low Frequency Split Phase Pure Sine Wave Solar Power Inverter
DC 24V to AC 110V & 220V 60Hz
AC 110V: 4000W continue power, 16000w peak power
AC 220V: 4000W continue power, 1000w peak power
AC 110V & 220V at the same time: 4000W continue power, 16000w peak power
Without 110v output LCD Display
Without 110V Battery Charger & UPS
With Power Save on
For L1,N,L2 AC output
L1+N=110V (L1 is Live,N is Neutral) (110V Output Preferred Interface)
L2+N=110V(L2 is Live,N is Neutral)
L1+L2=220V(L1 is 220v Live,L2 is 220v Live)
Environmental friendly material-stainless steel, in order to protect the environment,no spray paint, no environmental pollution. Although no beautiful outside , but it protects environment and also saves some cost. we will reduce this cost to buyer directly and offer a better price for buyer.
POWER SAVE ON :
If you only connect battery with load, ac cable unconnect, when you switch to battery charger mode, this means is power save mode on, in this moment the condition as follows: The inverter will go to sleeping mode , no load current is 0 AMP, every 3secs, the inverter will detection itself, after the 3sec, amp will go to 3amp(stand by power, time: 1sec, then back to sleep mode, amp is 0), the inverter will repeat the situation, until you switch to power save off(inverter on, down side)
some customer need use refrigerator can switch to power save on mode, as refrigerator only will work every half an hour or one hour , but inverter stay in power save function, no load current is 0amp , can save power.
When toggled this inverter will power on every 4 seconds and check for a load of 25 watts or greater. If no load is detected it will power down and wait 4 seconds. This mode is perfect for items that do not run continuously such as refrigerators and freezers. It will save on standby draws where energy saving is critical. This mode uses approximately 1/3 the standby draw.
Seller's Command:
1.Note: this item is 24V DC Input, usually when you use big power,the best Input voltage is 24V,because the amp will become small, will not cause the inverter getting so hot, if inverter not hot, the efficiency will arrive 2-3%,means can go to 92-94%, also your battery bank can keep very good performance! watt=volt x amp, once your voltage getting high, your amp will become small.
2.this inverter will come unversal plug with big amp socket, all the coutnry can be used!.
3.this inverter is LF inverter, we called low frequency, with big transformer inside(around 12kgs),this design just for the heavy duty appliance, like pump, motor, freezer, grinder, microwave, heater.
I sold the inverter about 10more years, most of is HF INVERTER(made by mosfet), even it's 5000w inverter,still get some feedback from customers side, they say why i use pump, grinder can not turn it on? or use some weeks, the inverter dead, because some heavy appliance maybe just 500w, however, when turn it on need 10-15times conitnue power(5kw-7.5kw) to start it, in this moment, very easy to damage the mos-fet, it happened all the