Vibob Molex to 3 x 3 pin Fan 20cm Y Splitter Power Cable 12v Black Sleeved

Power from PSU Molex 4-pin LP4, supporting three PWM fans from a single motherboard header Since only one RPM signal can be read by one motherboard connector, only one 4 TIPS CONNECTOR of the fan splitter cable carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to full 4-pin connector. The other two male connectors are missing the pins of tachometric signals; ensure your fan speed monitor won't bounce all over the place from getting three sense signals. Guarantee motherboard getting an accurate RPM signal.

Only one of the three fans sends its tach signal (the one with full 4-pin connector) reports its RPM, but the others will still follow the PWM signal. Power from PSU 12V DC only, do not utilize for 5V DC fan, Sleeved in a black is enhanced cable management, enclosure to provide a sleeker look that seamlessly integrates into the case's interior
Specifications Color: black sleeved cable
Wire Gauge: 26AWG Tinned Copper - UL1007 Wire
Cable Length: 20cm
Connector A: 1 - 5.25" Molex 4 pin LP4 Male
Connector B: 3-3pin housing DC 12v
Note: Only the fan on 'CPU Fan' channel is used for monitoring. All connected fans are following the same PWM signal speed control is the same for all fans when use fan controller software like AI stuite/Xspert FAN and EASY TUNE, etc PWM capable connectors must necessarily be 4-pin, but not all 4-pin motherboard connectors implement or enable the PWM signal modulation by default. Please carefully consult your motherboard documentation in this respect. This is only a fan splitter cable, NOT fan speed controller, Only 4pin PWM fans speed can be adjusted by fan controller software, 3pin fan would run in full speed, can not be adjusted when connect.