ATX 24Pin Power Supply Synchronizer Start Switch Test Cable, PSU Jumper Bridge Starter Adapter Cord for Multiple Mining Power Supply Simultaneous Booting and Power Source Testing

This 24Pin ATX PSU start switch cable is a professional practical tool specially developed for computer power supply offline detection and multi-power synchronous startup of cryptocurrency mining rigs. By inserting this dedicated jumper cable into the standard 24Pin main power interface of the ATX power supply, it can directly short the PS-ON trigger pin and the ground pin inside the connector, so the power supply can be activated and run independently without being connected to a computer motherboard.

The most core application scenario is multi-power parallel deployment for mining equipment. When a single power supply cannot bear the load of multiple graphics cards, users can match one synchronizer cable for each spare PSU to achieve one-key simultaneous startup of all power units, simplifying the startup operation of the entire mining frame and avoiding the trouble of manually plugging and unplugging jumpers one by one. Besides mining rigs, it is also widely used for daily maintenance and inspection of switching power supplies by computer repair technicians. You can easily judge whether the PSU fan rotates normally, whether each voltage rail outputs stably, and quickly eliminate faulty power supplies to prevent hardware burnout caused by defective power sources.

The wire harness adopts thickened conductive wire core with strong load capacity, which can withstand long-term continuous power-on operation without overheating or voltage drop. The injection-molded 24Pin plastic plug is precisely molded according to the ATX standard, with tight fit and no loose contact after insertion, effectively avoiding poor conduction and accidental power cut during heavy load operation. The operation is extremely simple and fully plug-and-play, just plug the cable into the 24Pin female port of the power supply, then connect the AC mains cord, and the power supply will start to work immediately.

It is compatible with all mainstream ATX, ATX 2.0, ATX 3.0 full modular, semi-modular and non-modular desktop power supplies on the market. Apart from mining machine multi-PSU linkage and power offline testing, it can also be used for DIY bench power transformation, old power supply secondary utilization, laboratory simple power debugging and other scenarios, a low-cost indispensable auxiliary tool for computer maintenance personnel, mining rig builders and electronic DIY enthusiasts.