DTech FTDI USB to TTL Serial 3.3V Adapter Cable TX RX Signal 3 Pin 0.1 inch Pitch Female Socket FT232RL Chip Windows 11 10 8 7 Linux MAC OS (3ft, Black) 3 ft.

Features:

3 ft USB to TTL serial adapter (with 3 pin 0.1" pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a laptop via USB port

A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates

3 feet FTDI USB to TTL serial cable (3 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx and GND

FTDI chipset on the PCB board has configurable internal EEPROM and 3.3V UART signals can be individually inverted by configuring the EEPROM

3V3 TTL to USB converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater; ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc.

3-Foot FT232RL FTDI USB to serial TTL adapter cable for 3.3 V logic level serial communication (rx, tx and GND)

It is built with FTDI FT232 chip, FTDI’s royalty-free VCP allow for communication as a standard COM port and D2XX ‘direct’ drivers provide DLL application programming interface; a great conversion data cord to meet with your needs of debugging, boot-loading, programming, etc.

NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FTDI official website

The original FTDI chip is embedded in the USB-A end; 3 way 0.1” header connector with GND (ground), RX and TX at 3V3 logic level.

Applications:
Upgrading Legacy Peripherals to USB
Interface Microcontroller UART or I/O, FPGA / PLD to USB
Replace MAX232 type level shifters allowing for direct connection of products to PC
Industrial Control / USB Software / Hardware Encryption Dongles

Features
- The I/O pins of the FTDI wire are configured to operate at 5.0V logic level - Entire USB protocol handled by the electronics in the cable;
- UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity;
- Data transfer rates from 300 to 3M baud rate at TTL levels;
- Internal EEPROM with users writable area; - Supply voltage comes from USB bus, no external supply required;
- UHCI / OHCI / EHCI host controller compatible

Specific
Interfaces: USB 2.0 type A Male Port ; 3 pin Female Socket flying leads
Supports Windows 2008, XP and XP 64-bit, Vista and XP 64-bit, CE 4.2, 5.0 and 6.0; Windows 7, 8, 8.1, 10, 11 (32 and 64-bit); Mac OS 8/9 , OS-X; Linux 2.4 and greater

What’s Included
1 x USB to Serial TTL Level Converter Cable
1 X User Manual