Q: How many hard drives and SSDs can this case fit?

2 desktop (3.5") and 2 laptop hdds (2.5")

Q: How much watt power does the Panel need?

not enough to even worry about. as long as you have enough to run your system with a small bit of surplus you should be good.

Q: How possible is it to mount a 280mm radiator? I read a review saying it was possible and saw a youtube video on it as well. But specs say only 240mm???

I have mounted a NZXT Kracken X63 in the front but the fans had to front mounted to clear the front panel IO ledge.

Q: would a Noctua NH-D15 fit in using two Fans, note that one of them would be resting on top Ram sticks making it stick out more? Also what is the distance between the surface of the motherboard and the inside of the panel?

I have two of these. One from Ibuypower where they installed the ENERMAX AQUAFUSION 240MM on the side intake and the other with an ASETEK 550 with front and rear fan attached. The only problem I had with the second was that I installed it to the rear exhaust vent and made a low lighting situation for the LCD display around the cooling. The distance between my Asrock Z390 Phantom MB and the LCD Panel is roughly 5.5 inches.

Q: Will this case fit a 315 mm graphics card such as the XFX RX 5700 XT THICC III Ultra?

Yes! It fits my RTX 2080ti with no problem.

Q: Does the case include any fans or will I have to purchase some?

Based on the iBUYPOWER website the case should include 3, 120mm fans. 1 in the rear and 2 on the side.

Q: What are the cooling solutions for this case? what kind of fan configurations are possible? I would like to put a 240mm radiator in and an extra fan or two? thank you!

The case is a bit limited on cooling solutions, you have 2 120mm intake fans on the side panel, and 1 120mm exhaust on the back panel. It supports up to a 240mm radiator, but there are no additional fan locations.

Question 1

would a Noctua NH-D15 fit in using two fans, note that one of them would be resting on top of the ram sticks?
Also what is the distance between the surface of the motherboard and the inside of the panel?

Accepted Answer

I personally had issue with the height of my RAM sticks (CRUCIAL Ballistix Sport LT) interfering with the right fan attached to the cooler. This caused me to be unable to close the LCD panel without damaging the components (the fan pressing itself into the panel). I currently run just the one fan in the center of the two fin stacks, and it is very low clearance but fits. I also have the Chromax heat sink covers on, those add minimal height. That being said, this is not necessarily the case for all RAM heights/MOBO layouts, and I would encourage trying this yourself.

Question 2

Will the GA-Z170X-Gaming 7 (rev 1.0) fit in this case?

Accepted Answer

This case will fit 99.9% of standard ATX motherboards, including your gigabyte board, with maybe <7 mm of clearance on the top and bottom.

Question 3

How many hard drives and SSDs can this case fit?

Accepted Answer

2 desktop (3.5") and 2 laptop hdds (2.5")

Question 4

How much watt power does the Panel need?

Accepted Answer

not enough to even worry about. as long as you have enough to run your system with a small bit of surplus you should be good.

Question 5

How possible is it to mount a 280mm radiator? I read a review saying it was possible and saw a youtube video on it as well. But specs say only 240mm???

Accepted Answer

I have mounted a NZXT Kracken X63 in the front but the fans had to front mounted to clear the front panel IO ledge.

Question 6

would a Noctua NH-D15 fit in using two Fans, note that one of them would be resting on top Ram sticks making it stick out more?
Also what is the distance between the surface of the motherboard and the inside of the panel?

Accepted Answer

I have two of these. One from Ibuypower where they installed the ENERMAX AQUAFUSION 240MM on the side intake and the other with an ASETEK 550 with front and rear fan attached. The only problem I had with the second was that I installed it to the rear exhaust vent and made a low lighting situation for the LCD display around the cooling. The distance between my Asrock Z390 Phantom MB and the LCD Panel is roughly 5.5 inches.

Question 7

would a Noctua NH-D15 fit in using two fans, note that one of the fans would be touching the Ram sticks making the fan stick out more?
Also what is the distance between the  motherboard and the panel ?

Accepted Answer

No idea

Question 8

Will this case fit a 315 mm graphics card such as the XFX RX 5700 XT THICC III Ultra?

Accepted Answer

Yes! It fits my RTX 2080ti with no problem.

Question 9

Does the case include any fans or will I have to purchase some?

Accepted Answer

Based on the iBUYPOWER website the case should include 3, 120mm fans. 1 in the rear and 2 on the side.

Question 10

What are the cooling solutions for this case? what kind of fan configurations are possible? I would like to put a 240mm radiator in and an extra fan or two? thank you!

Accepted Answer

The case is a bit limited on cooling solutions, you have 2 120mm intake fans on the side panel, and 1 120mm exhaust on the back panel. It supports up to a 240mm radiator, but there are no additional fan locations.

Questions & Answers