Pres-On 1/8 inch thick Gasketing Foam Tape: 2 in. (48mm actual) x 100 ft. x 1/8 in. thick (Black)

Pres-On 1/8 inch thick Gasketing Foam Tape is an ultra-soft, open-cell polyester polyurethane foam tape made for gasketing and sealing. The fine, reticulated foam stays flexible and breathable, conforming to uneven surfaces to seal out moisture, dust, and drafts while helping reduce sound and vibration.

One side is coated with a high-tack rubber pressure-sensitive adhesive and protected by a release liner for easy application. The adhesive grabs quickly and holds on many surfaces, and the foam resists aging and weather for long-lasting performance.

• Open-cell polyester polyurethane foam, ultra soft and flexible
• High-tack rubber adhesive on one side with peel-off release liner
• Resists water, moisture, aging, and weather
• Seals out dust and drafts and helps dampen sound and vibration
• Ideal for RV and automotive door gaskets, filters, and HVAC

Country of Origin: United States.Application Instructions

1. Measure the area to be sealed and cut the foam tape to length with scissors or a sharp blade.
2. Thoroughly clean the contact surface so it is free of dirt, oil, and moisture, then let it dry.
3. For best adhesion, make sure the surface and tape are between 50°F and 80°F.
4. Peel back a short section of the release liner at one end.
5. Position the tape carefully and press it into place, removing the liner as you go.
6. Apply firm, even pressure along the full length so the adhesive makes full contact with all surfaces.
7. Once applied, the tape cannot be removed and reused, so discard any misaligned piece and reapply with a fresh length.

NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 1/8 in. thick foam x 48mm x 30.5m. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first.