JVFYI PCIe 82576 Gigabit SC Fiber Network Adapter

PCI-Express host interface specification v2.0 with 2.5GT/s Bus width

On-board 850nm/1.25G multimode fiber supports up to 550 Meters fiber optic data transmission.

Optical interface: SC dual line

Complies with the IEEE802.3ab specification

Layer 2 functions: IEEE 802.3x Flow Control - IEEE 802.1q VLAN

Supports Receive-side scaling (RSS)

Supports IPv 4, IPv 6 protocols

Supports Jumbo Frames up to 9.5K

Supports UDP.TCP and IP Checksum offloading

Statistics for management and RMON

Support for virtual machines device queues

Next Generation VMDq Support (8VMs)

Interrupt throttling control to limit maximum interrupt rate and improve CPU usage

Chipset: JL82576EB

Drivers support for FreeBSD, Linux , VMWare ESXi, Win7/ Win-server2012/ Win-server2008/ Win8/Win8.1/Win-server2016/win10

Feature table

Product Name PCIe INTEL 82576 Gigabit SC Fiber Network Adapter

Bus Type PCI Express 2.1(2.5GT/s)

Data rate supported 1000Mbps

IEEE Standard 1000BASE-SX/LX

Cable Distance 1000BASE-SX: 275 m at 62.5 µm; 550 m at 50 µm

1000BASE-LX: 10Km at 9µm;

Interrupt levels INTA,INTB,INTC,INTD,MSI,MSI-X

Chipset Intel Ethernet Controller JL82576EB

Power Consumption 2.4W

Operating temperature 0 to 70(32 to 158)

Storage temperature -40-70(-40 to 158)

Storage humidity 90% non-condensing relative humidity at 35

LED Indicators Link/Activity LED:off=NO Link, ON=link;Blinking=Activity

Package content

1 x PCIe INTEL 82576 Gigabit SC Fiber Network Adapter

1 x Users Manual

1 x CD

1 x Low profile bracket

Accessories

System Requirements

FreeBSD, Linux Kernel2.4 or higher, VMWare ESXi, Win7/ Win-server2012/ Win-server2008/ Win8/Win8.1/Win-server2016//Win-server2019/Win-server2022/win10/Win11

One available PCI Express x1/x4/x8/x16 slot

Hardware installation

1.Turn off the computer and unplug the power cord

2.Remove the computer cover and the adapter slot cover from the slot that matches your adapter

3.Insert the adapter edge connector into the slot and secure the bracket to the chassis

4.Replace the computer cover, then plug in the power cord

5.Power on the computer

Install Drivers and software

Windows Operating Systems

You must have administrative rights to the operating system to install the drivers.

1.insert the CD driver bound with Intel network driver into your CD-ROM drive(also you can download the latest drivers from support website):

2.if the Found New Hardware Wizard screen is displayed, click Cancel

3.start the autorun located in the software package, the autorun may automatically start after you have extracted files.

4.Click install Drivers and Software

5.Follow the instructions in the install wizard to finish it

Installing Linux Drivers from Source Code

1.Download and expand the base driver tar file.

2.Compile the driver module

3.Install the module using the modprobe command

4.Assign an IP address using the ifconfig command

Support

More information and settings, please refer to the Intel Adapter User Guides or you can contact us.